We present a simulation strategy using ATLAS-2D to optimize the back-contact hole grid (i.e., size and pitch of openings) of the Al 2 O 3 -rear-passivation layer in ultrathin Cu(In,Ga)Se 2 photovoltaic cells. We first discuss and compare our simulation model with a series of experimental nonpassivated and passivated cells to decouple the crucial passivation parameters. The simulation results follow the experimental trends, highlighting the beneficial effects of the passivation on the cell performances. Furthermore, it stresses the influence of the passivation quality at the Al 2 O 3 /Cu(In,Ga)Se 2 (CIGS) interface and of the contact resistance at the Mo/CIGS interface within the openings. Further simulations quantify significant improvements in short-circuit current and open-circuit voltage for different sizes of openings in the Al 2 O 3 layer, relative to an excellent passivation quality (i.e., high density of negative charges in the passivation layer). However, a degradation is predicted for a poor passivation (i.e., low density of such charges) or a high contact resistance. Consequently, we point out an optimum in efficiency when varying the opening widths at fixed hole-pitch and fixed contact resistance. At equivalent contact resistance, simulations predict that the sizes of the pitch and openings can be increased without optimal performance losses when maintaining a width to pitch ratio around 0.2. This simulation trends have been confirmed by a series of experiments, indicating that it is crucial to care about the dimensions of the opening grid and the contact resistance of passivated cells. These simulation results provide significant insights for optimal cell design and characterizations of passivated UT-CIGS PV cells.
1 September 2019 in Solar Energy Materials and Solar Cells
Interface recombination in sub-μm optoelectronics has a major detrimental impact on devices’ performance, showing the need for tailored passivation strategies to reach a technological boost. In this article, SiO x passivation based substrates were developed and integrated into ultrathin Cu(In,Ga)Se 2 (CIGS) solar cells. This article aims to understand the impact of a passivation strategy, which uses several SiO x layer thicknesses (3, 8, and 25 nm) integrated into high-performance substrates (HPS). The experimental study is complemented with 3-D lumerical finite-difference time-domain and 2-D Silvaco ATLAS optical and electrical simulations, respectively, to perform a decoupling of optical and electronic gains, allowing for a deep discussion on the impact of the SiO x layer thickness in the CIGS solar cell performance. This article shows that as the passivation layer thickness increases, a rise in parasitic losses is observed. Hence, a balance between beneficial passivation and optical effects with harmful architectural constraints defines a threshold thickness to attain the best solar cell performance. Analyzing their electrical parameters, the 8-nm novel SiO x based substrate achieved a light to power conversion efficiency value of 13.2%, a 1.3% absolute improvement over the conventional Mo substrate (without SiO x ).
18 December 2019 in Informacije MIDEM - Journal of Microelectronics, Electronic Components and Materials
This letter investigates the large spread of values of capacitance measured in Si/TiO2 MIS structures for different properties of the TiO2 layer and proposes an approach to understand the behavior of the system. Experimental results show large variations of the maximum capacitance with TiO2 thickness for the as-deposited structures and further highlight the change of trend after annealing. Simulations qualitatively depict the theoretical trends explaining the C–V characteristics to the first order, by the different behaviors of the oxide layer in the structure and the distribution of the majority carriers showing depletion effects.