Purpose: The purpose of this paper is to investigate thermoregulation properties of different composite phase change materials (PCMs), which could be used in the high temperature environmental conditions to protect human body against the extra heat flow. Design/methodology/approach: Three kinds of composite PCM samples were prepared using the selected pure PCMs, including n-hexadecane, n-octadecane and n-eicosane. The DSC experiment was performed to get the samples’ phase change temperature range and enthalpy. The simulated high temperature experiments were performed using human arms in three different high temperature conditions (40°C, 45°C, 50°C), and the skin temperature variation curves varying with time were obtained. Then a comprehensive index TGP was introduced from the curves and calculated to evaluate the thermoregulation properties of different composite PCM samples comprehensively. Findings: Results show that the composite PCM samples could provide much help to the high temperature human body. It could decrease the skin temperature quickly in a short time and it will not cause the over-cooling phenomenon. Comparing with other two composite PCM samples, the thermoregulation properties of the n-hexadecane and n-eicosane composite PCM is the best. Originality/value: Using the n-hexadecane and n-eicosane composite PCM may provide people with better protection against the high temperature conditions, which is significative for the manufacture of functional thermoregulating textiles, garments or equipments.
We present finite element simulations of the transition-edge sensor (TES) microcalorimeter behavior using COMSOL Multiphysics. The simulated detector has a large absorber with a size of 990×990μm2. The simulation calculates the TES response after x-ray impact for a single pixel with a known, realistic, current-dependent resistive transition R(T,I). The simulation includes the full electrothermal feedback effects and heat conduction through the multiple contact points of the absorber to the TES thermometer and supporting membrane. The presented model, especially the 2D model, has been optimized for high accuracy, making it suitable for simulating the detector response when incident photons hit different positions on the absorber. We study the effects of position dependence using Principal Component Analysis with the aim of extracting correct photon energies from the pulses. The simulations show that the degradation, i.e., the FWHM broadening, due to the pulse variations will be less than 0.7 eV at below 2 keV, while it can be significant (>1 eV) at a higher energy band. The simulation result for position dependence can guide the design of large-absorber detectors for future x-ray missions, such as the Hot Universe Baryon Surveyor.
1 March 2021 in Acta Biochimica et Biophysica Sinica
We present the development of a high-performance superconducting inductor-capacitor (LC) filter array tailored for the Diffuse x-ray Explorer (DIXE) payload. Specifically, this LC filter array is designed for a frequency-division multiplexing (FDM) readout system, which reads out signals from a 10 × 10 microcalorimeter array based on transition-edge sensor. Each filter consists of a superconducting spiral line inductor and a planar metal–insulator-metal capacitor. By employing atomic layer deposition to grow HfO 2 —a high- κ dielectric ( ϵr ∼ 20), we achieved an enhanced specific capacitance. This is a critical step toward the miniaturization of the LC filter chips to meet the stringent space constraints of the DIXE payload. An innovative top–down fabrication process was employed to minimize impurity contamination and material damage between films, ultimately resulting in a yield of 92.5%. The LC filter array samples were characterized at 60 mK using a vector network analyzer. The measured S 21 exhibits distinct resonance dips across 37 channels within the frequency range of 1–10 MHz, with the highest quality factors ( Q ) exceeding 250 00. Collectively, these results on high-density integration and high- Q performance of LC filter arrays have laid a solid foundation for the subsequent development and application of FDM in DIXE.