Guangdong Key Laboratory of Electromagnetic Control and Intelligent Robots, College of Mechatronics and Control Engineering, Shenzhen University, Shenzhen, China
Auto-generated profile, based on publicly available information
Xiaodong Yang
Guangdong Key Laboratory of Electromagnetic Control and Intelligent Robots, College of Mechatronics and Control Engineering, Shenzhen University, Shenzhen, China
Sliding mode control is widely used to enhance the speed control performance of permanent magnet synchronous motors (PMSM). However, the slow reaching onto the sliding surface and chatting phenomena of conventional sliding mode reaching law (SMRL) is still a challenging issue. This article proposes a novel adaptive SMRL (ASMRL) to solve these problems. This ASMRL includes the system state variables, an exponential function term bounded by the absolute value of the switching function, and an adaptive switching gain term influenced by the convergence of the system state. This approach efficiently accelerates the velocity at which the system state reaches the sliding mode surface and effectively suppresses chattering. Then an enhanced sliding mode controller is designed for the speed regulation of PMSM systems. Finally, mathematical stability analysis, numerical analysis, simulation, and experimental validation are conducted to demonstrate the effectiveness of the proposed method.
23 November 2023 in IEEE Transactions on Power Electronics
In this article, a communication-free optimal frequency control method for the dynamic wireless charging system of automated guided vehicle with high interoperability is proposed. By periodically monitoring the primary winding currents, the position of the receiver ( Rx ) can be located in real-time, and the transmitters which are strongly coupled to the Rx will be activated for power transmission. In order to improve the system efficiency, an optimal frequency control scheme for achieving zero-phase-angle is proposed. A proportional-integral loop is employed to achieve quick elimination of the reactive power in primary side. Experimental results show that the positioning and the optimal frequency tuning can be completed within 10 ms. The out-phase can be controlled within 3.57° in the worst case, and the system transfer efficiency is increased up to 11.1%. Rx s with different shapes are utilized in experiments as case studies, and the same performance is verified. The results prove the system has high interoperability. Without any bidirectional communication and auxiliary position sensor, the system with the proposed control strategy is proven to be reliable and eco-friendly.
23 August 2024 in IEEE Transactions on Industrial Electronics
In this article, a communication-free constant current (CC) and constant voltage (CV) Li-ion charging control method for dynamic wireless power transfer (DWPT) systems is proposed. The key challenge of traditional control schemes is the coupled mutual inductance and battery equivalent resistance, which leads them to solely allow either dynamic coupling condition or varying load resistance. In the proposed control method, by adopting an inductive secondary resonator, the mutual inductance and load resistance are decoupled in CV mode. The output current and voltage are controlled by estimating the bias between the real-time state and the reference steady state. The CC and CV modes are switched automatically without bidirectional communication. Hence, the proposed control method is featured with less time delay, fast dynamic performance, and low implementation cost. Both the simulation and experimental results prove that the proposed control scheme has high control precision (less than 4% steady-state error) and short settling time (less than 40 ms) in the CC/CV charging mode.
25 March 2024 in IEEE Transactions on Instrumentation and Measurement
This paper proposes a new detection method for foreign metal objects (FMOs) based on a new detection array. Compared with traditional foreign metal objects detection (FMOD), the proposed method can detect smaller FMOs without any external sensors. The nature of the method is to decouple the receiving coil ( R xs ) that has similar feedback characteristics to small-size FMOs. Hence, the cost of FMOD system is reduced in the actual implementation. Furthermore, this kind of FMOD does not require communication. So it has high stability and can be easily realized. Finally, the experiment results prove that the proposed method has a high effectiveness for detecting small-size FMOs (able to detect FMOs up to 1.08cm 2 ).
1 January 2026 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Accurate constant current (CC) and constant voltage (CV) charging in wireless power transfer (WPT) systems is challenging in practice because coil misalignment is inevitable during operation and the battery equivalent resistance varies nonlinearly during charging. These effects often degrade regulation accuracy and complicated transmitter (Tx) side control, particularly in communication-free systems. This article proposes a Tx communication-free CC/CV control method for series–series compensated WPT systems that remains effective under misalignment. The mutual inductance is identified prior to charging by detuning the receiver to alter reflected impedance, while the equivalent load is estimated online during charging. By decoupling mutual inductance from load variation prior to charging, a unified closed-form phase shift control law enables CC/CV regulation without receiver (Rx) side sensing, communication or auxiliary converters. Experimental results on a 50 W prototype show that mutual inductance estimation errors are below 6.4% and equivalent load errors within 3.1%. Under various coil misalignment conditions, the system maintains within 1% steady state regulation error for both CC and CV operation.