15 July 2021 in Psychological Medicine
Background: The objective of this population-based register study was (1) to investigate the association between young adults diagnosed with attention-deficit/hyperactivity disorder (ADHD) and subsequent labour market marginalisation (LMM) in two comparison groups, i.e. matched young adults from the general population without ADHD and unaffected siblings to persons with ADHD and (2) to assess the role of comorbid disorders.Methods: This study included all young adults in Sweden, aged 19–29 years, with an incident diagnosis of ADHD 2006–2011 (n = 9718). Crude and multivariate sex-stratified hazard ratios (HRs) with 95% confidence intervals (CIs) were measured 5 years after the diagnosis of ADHD for the risk of disability pension, long-term sickness absence (SA) (>90 days), long-term unemployment (>180 days) and a combined measure of all three in young adults with ADHD compared to their siblings without ADHD and a matched comparison group.Results: In the adjusted analyses young adults with ADHD had a 10-fold higher risk of disability pension (HR = 10.2; CI 9.3–11.2), a nearly three-fold higher risk of long-term SA (HR = 2.7; CI 2.5–2.8) and a 70% higher risk of long-term unemployment (HR = 1.7; CI 1.6–1.8) compared to the matched comparison group. The risk estimates were lower compared to siblings for disability pension (HR = 9.0; CI 6.6–12.3) and long-term SA (HR = 2.5; CI 2.1–3.1) but higher in the long-term unemployed (HR = 1.9; CI 1.6–2.1). Comorbid disorders explained about one-third of the association between ADHD and disability pension, but less regarding SA and long-term unemployment.Conclusions: Young adults with ADHD have a high risk for different measures of LMM and comorbidities explain only a small proportion of this relationship.
15 December 2017 in IEEE Transactions on Microwave Theory and Techniques
This paper presents the design, fabrication, and characterization of a zero-bias quasi-optical terahertz detector based on monolithically integrated heterostructure backward diodes (HBDs) for operation at G-band. The reported detectors consist of HBDs with 0.7 x 0.7 μm² active device area and submicrometer-scale airbridges, integrated with lens-coupled high-impedance planar folded dipole antennas. Measurements of the HBD detector show that a peak-measured detector sensitivity of approximately 2400 V/W and a minimum noise equivalent power (NEPmin) of 2.14 pW/√Hz have been obtained at 170 GHz. If an antireflection coating was used on the lens, a sensitivity of approximately 3500 V/W and NEPmin of 1.48 pW/√Hz is projected. The radiation patterns of the quasi-optical detector in both E- and H-planes have been measured, and good agreement has been achieved between simulation and measurement. The performance of this detector can be further improved by scaling the HBD device active area. The reported approach using monolithically integrated heterostructure backward tunneling diodes and submicrometer airbridges is promising for developing high performance and compact detectors and focal-plane arrays for millimeter-wave and terahertz sensing and imaging applications.
1 August 2015 in IET Microwaves, Antennas & Propagation
The authors report the design, simulation and characterisation of lens‐coupled folded‐dipole antennas (LC‐FDAs) for terahertz (THz) detection and focal‐plane imaging arrays. LC‐FDAs operating at 200 GHz have been designed on semi‐insulating silicon wafers with a resistivity larger than 20 000 Ω·cm. Even–odd mode analysis (EOA) has been performed to extract the currents of the two modes. The embedding impedance of the designed LC‐FDAs has been simulated using conventional numerical electromagnetics, and the results show that a wide range of impedance values (both real and imaginary parts) can be achieved by changing the antenna geometry. This property makes LC‐FDAs suitable for high‐performance THz detectors in which impedance matching between antennas and devices is desired. From the currents calculated using EOA, the LC‐FDA far‐field radiation patterns, antenna directivity and Gaussian coupling efficiency for different lens structures have been examined using ray‐tracing techniques. Good agreement between calculation results and measurement has been observed demonstrating the effectiveness of the above analysis approach. The single element FDA design has also been explored for use in high‐resolution two‐dimensional THz focal plane arrays by optimising the lens structure and evaluating the off‐axis radiation patterns.