Developing an engineering design is resource-intensive and time-consuming, particularly for the floats of a floatplane design, due to its complexity and limited testing facilities. Intelligent-based computational design (IBCD) techniques, which integrate computational design techniques and machine learning (ML) algorithms, offer a solution to reduce required testing by providing predictions. This paper proposes a deep learning (DL)-based IBCD method for modeling floats' lift-to-drag coefficient ratio (CL/CD), where DL is one of the most powerful ML. The proposed method consists of two phases: hyper-parameter optimization and DL model training and evaluation. A genetic algorithm (GA) is employed in the first phase to explore complex hyper-parameter combinations efficiently. Evaluation of the predicted CL/CD of the floats using the DL model resulted in a satisfactory R-squared of 0.9329 and the lowest mean squared error (MSE) of 0,001536. These results demonstrate the ability of DL model to predict the float's performance accurately and can facilitate further design optimization. Thus, the proposed method can offer a time-efficient and cost-effective solution for predicting float performance, aiding in optimizing floatplane designs and enhancing their functionalities.
A passive variable-pitch blade swings about its pivot until a mechanical stop arrests it, promising dynamic-stall relief without an actuator. But the stop makes that freedom an impact oscillator, which can settle into more than one stable motion at a single setting. Two-dimensional URANS of a three-bladed NACA 0021 hydrokinetic rotor at λ = 3.06, each blade's pitch solved as a coupled rigid body, covers a fixed-pitch baseline, six passive configurations and eight bolted presets. Two runs with the same ±10◦ stop, differing only in the sign of a small initial pitch-rate perturbation, settle at CP = 0.451 and 0.273, and blade mean torque splits into a productive band and a stalled band with nothing between. A one-sided stop moves incidence from the upstream half into the downstream half rather than reducing it, and costs 4.0% of CP; every passive case multiplies torque ripple by 5 to 21. Bolted presets do better: CP rises from -0.646 at +6◦ and plateaus near 0.44 between -6◦ and -8◦, a gain of 10.6 to 11.2% over fixed pitch with ripple below the baseline. For this rotor the simpler fix wins.
25 June 2023 in Jurnal Teknologi (Sciences & Engineering)
The ship model test was believed to be one of the effective methods for figuring out the boundaries and reliability of the ship's horsepower. The ship's form factor determines a full-scale ship's effective horsepower. Determination of the form factor value can be done experimentally through the Prohaska method. The new method proposed in this study is employed the regression Iteratively Reweighted Least Squares (IRLS) method by utilizing the principle dimension of the ship, such as LWL, B, CB, CP, CM, WSA, T, ∆. etc. The Indonesian Hydrodynamics Laboratory has a database of ships with various principle dimensions which have undergone the towing model test. Through the database, the form factor can be predicted with the IRLS method. The method is then verified and validated with the Prohaska method. The result shows a good agreement with the Prohaska method. The obtained results from the IRLS method also show that the EHP & Resistance calculations are identical with old fashion Prohaska methods. The residual bias factor established by the IRLS method was verified in comparison to the value of the form factor generated by the Prohaska method. Comparison between the two methods results in a small error.