1 May 2017 in Biomicrofluidics
Laser-induced forward transfer has been a promising orifice-free bioprinting technique for the direct writing of three-dimensional cellular constructs from cell-laden bioinks. In order to optimize the printing performance, the effects of living cells on the bioink printability must be carefully investigated in terms of the ability to generate well-defined jets during the jet/droplet formation process as well as well-defined printed droplets on a receiving substrate during the jet/droplet deposition process. In this study, a time-resolved imaging approach has been implemented to study the jet/droplet formation and deposition processes when printing cell-free and cell-laden bioinks under different laser fluences. It is found that the jetting behavior changes from no material transferring to well-defined jetting with or without an initial bulgy shape to jetting with a bulgy shape/pluming/splashing as the laser fluence increases. Under desirable well-defined jetting, two impingement-based deposition and printing types are identified: droplet-impingement printing and jet-impingement printing with multiple breakups. Compared with cell-free bioink printing, the transfer threshold of the cell-laden bioink is higher while the jet velocity, jet breakup length, and printed droplet size are lower, shorter, and smaller, respectively. The addition of living cells transforms the printing type from jet-impingement printing with multiple breakups to droplet-impingement printing. During the printing of cell-laden bioinks, two non-ideal jetting behaviors, a non-straight jet with a non-straight trajectory and a straight jet with a non-straight trajectory, are identified mainly due to the local nonuniformity and nonhomogeneity of cell-laden bioinks.
29 April 2020 in RSC Advances
We describe the instantaneous fabrication of a highly porous three-dimensional (3D) nanostructured manganese oxides-reduced graphitic oxide (MnOx-rGO) electrode by using a pulse-photonic processing technique.
11 February 2011 in Journal of Materials Science
1 August 1999 in Integrated Ferroelectrics
Epitaxial Ba1−xSrxTiO3 (BST) thin films have been deposited onto (100) MgO and LaAlO3 substrates using pulsed laser deposition. Thick (>1 μm) interdigitated capacitors have been deposited on top of the BST films. The capacitance and dielectric Q (1/tanΔ) of the structure has been measured at microwave frequencies (1–20 GHz) as a function of electric field (0–67 kV/cm) at room temperature. In epitaxial BST films, either high dielectric tuning (4:1) or high dielectric Q (∼100–250) was observed but not both at the same time. Film strain was measured using X-ray diffraction and is closely related to the dielectric properties as limiting the ability to obtain both high tuning and high Q in epitaxial BST thin films. A thin BST buffer layer was used to relieve the strain in the films. In strain-relieved films, both dielectric tuning and dielectric Q were increased after annealing. A theoretical analysis of the strain effect of the films is presented based on Devonshire thermodynamic theory.