31 March 2023 in Advanced Functional Materials
20 July 2020 in IEEE Transactions on Electron Devices
We demonstrate edge termination for vertical GaN p-n diodes using step-etched triple-zone junction termination extension (JTE). The technique was found to yield high breakdown efficiency without degradation of forward characteristics. The electric field distribution at various JTE thicknesses was simulated, and the experimental results were well matched to the simulation results. The fabricated GaN p-n diode with step-etched triple-zone JTE shows a breakdown voltage of 550 V corresponding to a junction termination efficiency of 75%, with a turn-on voltage of 3.1 V, a specific ON-resistance of 1.3 $\text{m}\Omega \cdot $ cm 2 , and leakage current at −200 V of 80 nA/cm 2 . The multistep JTE strategy demonstration could be important for future applications for multikilovolt-class GaN vertical power devices.
9 September 2020 in Light: Science & Applications
We identify and characterize a novel type of quantum emitter formed from InGaN monolayer islands grown using molecular beam epitaxy and further isolated via the fabrication of an array of nanopillar structures. Detailed optical analysis of the characteristic emission spectrum from the monolayer islands is performed, and the main transmission is shown to act as a bright, stable, and fast single-photon emitter with a wavelength of ~400 nm.
11 September 2023 in Applied Physics Letters
A detailed study comparing defect incorporation between laser-assisted metal-organic chemical vapor deposition (MOCVD)-grown GaN and conventional low- and high-growth-rate MOCVD GaN was conducted. Using deep-level transient and optical spectroscopy, traps throughout the bandgap were characterized where traps were found at EC-0.25 eV, EC-0.57 eV, EC-0.72 eV, EC-0.9 eV, EC-1.35 eV, EC-2.6 eV, and EC-3.28 eV in all three samples. This indicates no new traps were observed in the laser-assisted MOCVD GaN sample. Overall, the trap concentrations in the laser-assisted MOCVD sample were ∼2× higher than the optimal low-growth-rate sample, but this is primarily due to the increase in gallium vacancy EC-2.6 eV and carbon-related EC-3.28 eV trap concentrations. The EC-0.9 eV trap concentration was ∼2× higher in the laser-assisted sample, so proton irradiation experiments were conducted to identify the physical source of this level. The results indicated this was a native point defect likely related to gallium interstitials. Overall, this study shows that the laser-assisted MOCVD growth method is promising for future thick, high-quality GaN epilayers after further growth optimizations.
1 March 2025 in Applied Physics Letters
Micro-LEDs, especially small-size micro-LEDs, have attracted increasing attention for high-resolution displays and high-speed visible light communications in recent years. However, the efficiency of micro-LEDs sharply decreases with decreasing device size due to sidewall damage resulting from the mesa etching. Therefore, the implementation of a low-damage pixelization technique is essential for enhancing the performance of micro-LEDs. In this Letter, ion implantation (IIP) was employed to improve the performance of InGaN green micro-LED arrays with a pixel size of around 6.5 μm and a resolution of 25 × 25. The peak external quantum efficiency of the micro-LED array is enhanced to 6.2%, which is much higher than the 2.4% of that fabricated by conventional inductively coupled plasma etching. In addition, the transmission data rate of the IIP-pixelized micro-LED array is 2.7 times higher, increasing from 115.5 to 307.3 Mbps at an operating current density of about 100 A/cm2. Our work will promote the advancement of high-performance micro-LED applications.
9 February 2026 in Applied Physics Letters
Scandium-alloyed aluminum nitride (ScAlN) has emerged as a promising ferroelectric material for next-generation electronics, optoelectronics, photonics, and acoustics due to its high remanent polarization (Pr), tunable coercive field (Ec), and compatibility with GaN, Si, and complementary metal–oxide–semiconductor technologies. However, ScAlN devices have been limited by large Ec and poor endurance. In this work, we report a Ti-assisted surface oxide layer reconstruction approach to enhance the performance of ferroelectric ScAlN. Ti/ScAlN/GaN capacitors were fabricated and subsequently annealed to promote oxygen migration from the native ScAlON into the Ti electrode, forming an insulating TiOx interfacial layer. This reconstruction reduced the polarization switching field and improved device reliability. At an optimized annealing temperature of 400 °C, the capacitors exhibited endurance up to 6 × 108 cycles with Pr exceeding 60 μC/cm2. These results demonstrate a viable strategy for improving the endurance of ferroelectric ScAlN and underscore the importance of interfacial engineering for nonvolatile memory and neuromorphic computing applications.