Amir Zulkefli

Amir Zulkefli

Auto-generated profile, based on publicly available information

Amir Zulkefli

International Center for Materials Nanoarchitectonics (WPI-MANA), National Institute for Materials Science (NIMS), 1-1 Namiki, Tsukuba 305-0044, Japan

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 August 2020 in Advanced Functional Materials
Verified
Journal Article
Closed access
PDF file
BMBablu Mukherjee
Bablu Mukherjee
AZAmir Zulkefli
Amir Zulkefli
KWKenji Watanabe
Kenji Watanabe
TTTakashi Taniguchi
Takashi Taniguchi
YWYutaka Wakayama
Yutaka Wakayama
SNShu Nakaharai
Shu Nakaharai

31 August 2021 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
AZAmir Zulkefli
Amir Zulkefli
BMBablu Mukherjee
Bablu Mukherjee
RSRyoji Sahara
Ryoji Sahara
RHRyoma Hayakawa
Ryoma Hayakawa
TITakuya Iwasaki
Takuya Iwasaki
SNShu Nakaharai
Shu Nakaharai

25 September 2022 in Advanced Electronic Materials
Verified
Journal Article
Open access
YSYoshitaka Shingaya
Yoshitaka Shingaya
AZAmir Zulkefli
Amir Zulkefli
TITakuya Iwasaki
Takuya Iwasaki
RHRyoma Hayakawa
Ryoma Hayakawa
SNShu Nakaharai
Shu Nakaharai
YWYutaka Wakayama
Yutaka Wakayama
A dual‐gate anti‐ambipolar transistor (AAT) with a two‐dimensional ReS2 and WSe2 heterojunction is developed. The characteristic Λ‐shaped transfer curves yielded by the bottom‐gate voltage are effectively controlled by the top‐gate voltage. This feature is applied to logic operations, with the bottom‐ and top‐gate voltages acting as two input signals and the drain current (Id) monitored as an output signal. Importantly, a single dual‐gate AAT exhibits all the two‐input logic operations (AND, OR, XOR, NAND, NOR, and XNOR) under optimized input voltages. Additionally, drain voltage (Vd)‐induced switching between AND and OR logic operations is achieved. These features are advantageous for simplifying circuit design.

21 August 2019 in ACS Photonics
Verified
Journal Article
Closed access
BMBablu Mukherjee
Bablu Mukherjee
AZAmir Zulkefli
Amir Zulkefli
RHRyoma Hayakawa
Ryoma Hayakawa
YWYutaka Wakayama
Yutaka Wakayama
SNShu Nakaharai
Shu Nakaharai

31 July 2017 in Micromachines
Verified
Journal Article
Open access
PDF file
MZMohd Amir Zulkefli
Mohd Amir Zulkefli
MMMohd Ambri Mohamed
Mohd Ambri Mohamed
KSKim Siow
Kim Siow
BMBurhanuddin Yeop Majlis
Burhanuddin Yeop Majlis
JKJothiramalingam Kulothungan
Jothiramalingam Kulothungan
Hiroshi MizutaHiroshi Mizuta
Hiroshi Mizuta
The miniaturization trend leads to the development of a graphene based nanoelectromechanical (NEM) switch to fulfill the high demand in low power device applications. In this article, we highlight the finite element (FEM) simulation of the graphene-based NEM switches of fixed-fixed ends design with beam structures which are perforated and intact. Pull-in and pull-out characteristics are analyzed by using the FEM approach provided by IntelliSuite software, version 8.8.5.1. The FEM results are consistent with the published experimental data. This analysis shows the possibility of achieving a low pull-in voltage that is below 2 V for a ratio below 15:0.03:0.7 value for the graphene beam length, thickness, and air gap thickness, respectively. The introduction of perforation in the graphene beam-based NEM switch further achieved the pull-in voltage as low as 1.5 V for a 250 nm hole length, 100 nm distance between each hole, and 12-number of hole column. Then, a von Mises stress analysis is conducted to investigate the mechanical stability of the intact and perforated graphene-based NEM switch. This analysis shows that a longer and thinner graphene beam reduced the von Mises stress. The introduction of perforation concept further reduced the von Mises stress at the graphene beam end and the beam center by approximately ~20–35% and ~10–20%, respectively. These theoretical results, performed by FEM simulation, are expected to expedite improvements in the working parameter and dimension for low voltage and better mechanical stability operation of graphene-based NEM switch device fabrication.

8 September 2020 in Physica Status Solidi (RRL) – Rapid Research Letters
Verified
Journal Article
Closed access
PDF file
AZAmir Zulkefli
Amir Zulkefli
BMBablu Mukherjee
Bablu Mukherjee
RHRyoma Hayakawa
Ryoma Hayakawa
TITakuya Iwasaki
Takuya Iwasaki
SNShu Nakaharai
Shu Nakaharai
YWYutaka Wakayama
Yutaka Wakayama