Faculty of Mechanical Engineering, Czech Technical University in Prague , Department of Mechanics, Biomechanics and Mechatronics , Technická 4, 166 07 Praha , Czech Republic
Auto-generated profile, based on publicly available information
Pavel Růžička
Faculty of Mechanical Engineering, Czech Technical University in Prague , Department of Mechanics, Biomechanics and Mechatronics , Technická 4, 166 07 Praha , Czech Republic
Presented work describes the use of algorithm for the computation of thermo-elastic properties of randomly reinforced composite which is based on histogram from image analysis done on ITAM, CAS. Three polished samples from “Bearing” part were analyzed. Results are used for verification of the algorithm functionality and primarily for computation of thermo-elastic properties which were compared with each other and used in modified FE analysis.
This paper deals with a knee joint endoprosthesis finite element analysis. Based on a three dimensional geometric model of a lower extremity, a mechanical axis of the limb was designed. This axis is important for several reasons. Firstly, the endoprosthesis was positioned due to its direction, secondly, boundary conditions was defined on its proximal and distal end and finally, the axis enabled reasonable simplification of the model which led to the time saving analysis while preserving principal features of the model like the natural boundary conditions or knee joint's degrees of freedom . Having this, one leg stance was simulated. Results of the analysis were encouraging for future models. Especially the choice of the mechanical axis was suitable and enabled a better distribution of contact pressures and stress on both femoral and tibial component compared to our former models. Also their magnitudes correspond better the manufacturer's experience and our findings. The stresses did not exceeded 30 MPa for the UHMWPE tibial plateau and 100 MPa for the femoral component. The contact pressures were lower than 40 MPa.