17 October 2018 in Macromolecules
A simple and versatile method is described to obtain polycaprolactone (PCL) porous membranes, consisting of fibers prepared by electrospinning. The surface of the fibers is modified by grafting poly(N-isopropylacrylamide) (PNIPAM) brushes by surface-initiated atom-transfer radical polymerization (SI-ATRP). PCL mixtures, featuring Br end-functionalized and nonfunctionalized polymer, are used to enable SI-ATRP. Wettability at variable temperatures is governed by the lower critical solution temperature (LCST) of PNIPAM as contact angle and swelling ratio measurements demonstrate. Because of the PNIPAM LCST, the membranes show a variation of pore size with temperature, which is accompanied by flux changes of water permeating the membranes. Temperature gated separation is demonstrated using oil/water emulsions at 1 bar pressure. Typical separation efficiencies are 92% and 25% at 25 and 50 °C, respectively. Employment of anionic and neutral surfactants shows that the separation efficiency also depends on the interaction between the membranes and the emulsions.
23 December 2015 in RSC Advances
In this study, we prepared electrospun polyacrylonitrile (PAN) nanofibers functionalized with dibenzo-18-crown-6 (DB18C6) crown ether and showed the potential of these fibers for the selective recovery of K+ from other both mono- and divalent ions in aqueous solutions. Nanofibers were characterized by SEM, FTIR and TGA. SEM results showed that the crown ether addition resulted in thicker nanofibers and higher mean fiber diameters, in a range of 138 to 270 nm. Batch adsorption experiments were conducted in order to evaluate the potential of the crown ether modified nanofibers as an adsorbent for ion removal. The maximum adsorption capacity of the crown ether modified nanofibers for K+ was 0.37 mmol g−1 and the nanofibers followed the selectivity sequence of K+ > Ba2+ > Na+ ∼ Li+ for single ion experiments. Adsorption of Ba2+ ions onto crown ether-modified nanofiber was examined by XPS and the results confirmed the adsorption of the ion. Mixed ion adsorption experiments revealed competitive adsorption between K+ and Ba2+ ions for the available binding sites. This effect was not observed for the other monovalent ions present in the solution and exceptionally high selectivities for K+ over Li+ and Na+ were obtained. Also the crown ether modified nanofibers exhibited good regeneration properties and a good reusability over multiple consecutive adsorption–desorption cycles. Electrospinning is thus shown to be a very versatile tool to prepare crown ether functional polymer adsorbents for the selective recovery of ions.
22 July 2019 in Advanced Functional Materials
27 May 2016 in RSC Advances
Blend membranes of sulfonated poly(ether ether ketone) (SPEEK) and poly(arylene ether ketone) (PAEK) derivatives containing crown ether units in the main chain (CPAEK) were prepared and characterized in terms of water swelling and ion exchange capacity (IEC). The miscibility of the polymers was verified by DSC and HR-SEM. Ion transport characteristics of the membranes were established for the monovalent ions Li+ and K+ and the separation of these ions by the cation exchange membranes was investigated. Diffusion experiments for aqueous KCl, LiCl and their mixtures were carried out with pure SPEEK membranes as well as with the CPAEK/SPEEK membranes. Blending significantly decreased the ion permeability due to cation-crown ether complexation and increased the hydrophobicity of the matrix. The K+ over Li+ selectivity of the SPEEK membrane was enhanced by blending SPEEK with CPAEK by a factor of nearly 4, indicating that the presence of a crown ether polymer changes the relative transport of the ions in the membrane.
3 January 2019 in Macromolecular Chemistry and Physics
4 November 2010 in Journal of Thermal Analysis and Calorimetry