20 July 2020 in Journal of Advances in Modeling Earth Systems
Representing climate‐crop interactions is critical to Earth system modeling. Despite recent progress in modeling dynamic crop growth and irrigation in land surface models (LSMs), transitioning these models from field to regional scales is still challenging. This study applies the Noah‐MP LSM with dynamic crop‐growth and irrigation schemes to jointly simulate the crop yield and irrigation amount for corn and soybean in the central United States. The model performance of crop yield and irrigation amount are evaluated at county‐level against the USDA reports and USGS water withdrawal data, respectively. The bulk simulation (with uniform planting/harvesting management and no irrigation) produces significant biases in crop yield estimates for all planting regions, with root‐mean‐square‐errors (RMSEs) being 28.1% and 28.4% for corn and soybean, respectively. Without an irrigation scheme, the crop yields in the irrigated regions are reduced due to water stress with RMSEs of 48.7% and 20.5%. Applying a dynamic irrigation scheme effectively improves crop yields in irrigated regions and reduces RMSEs to 22.3% and 16.8%. In rainfed regions, the model overestimates crop yields. Applying spatially varied planting and harvesting dates at state‐level reduces crop yields and irrigation amount for both crops, especially in northern states. A “nitrogen‐stressed” simulation is conducted and found that the improvement of irrigation on crop yields is limited when the crops are under nitrogen stress. Several uncertainties in modeling crop growth are identified, including yield‐gap, planting date, rubisco capacity, and discrepancies between available data sets, pointing to future efforts to incorporating spatially varying crop parameters to better constrain crop growing seasons.
6 March 2018 in Journal of Geophysical Research: Atmospheres
5 August 2019 in Journal of Advances in Modeling Earth Systems
Correctly calculating the timing and amount of crop irrigation is crucial for capturing irrigation effects on surface water and energy budgets and land‐atmosphere interactions. This study incorporated a dynamic irrigation scheme into the Noah with multiparameterization land surface model and investigated three methods of determining crop growing season length by agriculture management data. The irrigation scheme was assessed at field scales using observations from two contrasting (irrigated and rainfed) AmeriFlux sites near Mead, Nebraska. Results show that crop‐specific growing‐season length helped capture the first application timing and total irrigation amount, especially for soybeans. With a calibrated soil‐moisture triggering threshold (IRR_CRI), using planting and harvesting dates alone could reasonably predict the first application for maize. For soybeans, additional constraints on growing season were required to correct an early bias in the first modeled application. Realistic leaf area index input was essential for identifying the leaf area index‐based growing season. When transitioning from field to regional scales, the county‐level calibrated IRR_CRI helped mitigate overestimated (underestimated) total irrigation amount in southeastern Nebraska (lower Mississippi River Basin). In these two heavily irrigated regions, irrigation produced a cooling effect of 0.8–1.4 K, a moistening effect of 1.2–2.4 g/kg, a reduction in sensible heat flux by 60–105 W/m2, and an increase in latent heat flux by 75–120 W/m2. Most of irrigation water was used to increase soil moisture and evaporation, rather than runoff. Lacking regional‐scale irrigation timing and crop‐specific parameters makes transferring the evaluation and parameter‐constraint methods from field to regional scales difficult.
24 May 2018 in Environmental Research Letters
30 July 2022 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
12 May 2020 in Journal of Solar Energy Engineering
Understanding how energy use responds to meteorological conditions is essential for anticipation of energy demands, which is of significance to maintain sufficient power supply and to prevent brownouts or blackouts during peak hours. Using the quarter-hourly and district-level electricity data for Beijing, this study calculates the district-varying cooling electric loads due to air-conditioning (AC) systems in five consecutive summers. Results show the occurrence of two major features that are common for summertime cooling loads in most districts, namely, double-peaked diurnal profiles and weekday–weekend fluctuations. With the increasing distance from the city core, the evening peak cooling load around 21:00 local time (LT) becomes more pronounced and comparable with its afternoon counterpart around 15:00 LT. Conversely, the weekday–weekend fluctuation is greatly weakened in suburban and rural districts due to the stable cooling demands on weekdays and weekends. The district-level sensitivity of peak cooling loads to surface meteorological factors is further investigated by linear regression analysis, and results show significant decreases from urban to rural districts. The correlation coefficients between peak cooling loads and heat index that combines air temperature and relative humidity reach up to 0.8–0.9 in most districts. If using air temperature or specific humidity solely, the coefficients of determination with peak cooling loads are roughly 0.1–0.3 smaller, possibly indicating the greater potential of heat index for effectively predicting peak cooling demands in Beijing.