22 April 2024 in Applied Physics Letters
Body-centered cubic (BCC) lightweight refractory high-entropy alloys (LWRHEAs) with Al contents have attracted much attention due to their low density and excellent mechanical properties. However, these typical lightweight alloys often suffer from poor room temperature plasticity. In this study, we prepared TiZrNbTa0.1Alx LWRHEAs by using a high-vacuum arc-melting technique and investigated the influence of Al content on the phase structures and mechanical properties. It was found that the TiZrNbTa0.1Al1 alloy showed a BCC solid solution matrix with some micrometer-sized Al3Zr5 precipitates and exhibited a density of 6.110 ± 0.003 g/cm3. The TiZrNbTa0.1Al1 alloy had a low mixed enthalpy of −20.831 kJ/mol, a compressive yield strength of 1037 ± 178 MPa, and a fracture plasticity of ∼6%. As a result of reducing the Al content, the TiZrNbTa0.1Al0.2 alloy showed a simple BCC phase structure without any precipitates and maintained a low density of 6.743 ± 0.008 g/cm3. The TiZrNbTa0.1Al0.2 alloy had a relatively high mixed enthalpy of −4.5577 kJ/mol, a high yield strength of 1022 ± 51 MPa, and a plasticity of >70%. The TEM analysis results demonstrated that the excellent mechanical properties of this LWRHEA were mainly attributed to the reducing Al content, which could elevate the mixed enthalpy of the alloy to eliminate the brittle Al3Zr5 phase and induce the formation of dense network dislocations at the grain boundaries.
1 March 2025 in Applied Physics Letters
Low-activation refractory high-entropy alloys (LARHEAs) as structural materials have a great demand in nuclear reactors. However, currently developed LARHEAs generally have poor room temperature ductility, which greatly limits their wide applications. In this study, two kinds of LARHEAs with chemical compositions of TiZrTaCr and TiZrTaV in equal atomic percentage were designed based on low neutron absorption cross section, low neutron activation, and mixing enthalpy parameters. The LARHEA samples were prepared by high vacuum arc-melting techniques, and their phase structures and mechanical properties were studied. It was found that the TiZrTaCr LARHEA exhibited two body-center-cubic (BCC) and one Cr2Zr intermetallic compound phases, and it had a yield strength of 1364 ± 54 MPa, but it was brittle, while the TiZrTaV LARHEA formed three BCC solid solution phases, and it had a high yield strength of 1312 ± 57 MPa with a room temperature compression plasticity of 13% ± 0.8%. Cr2Zr intermetallic compound formation in the solid solution matrix could have led to the brittleness of the LARHEAs, which was mainly due to the large negative mixing enthalpy of the Cr element with Zr element in this alloy system. This study proposed a basic method for LARHEA design to optimize the microstructures and improve the mechanical properties as structural materials.