11 January 2019 in IEEE Transactions on Instrumentation and Measurement
1 January 2010 in Measurement Science Review
22 February 2024 in IEEE Transactions on Instrumentation and Measurement
This paper presents a method for improving the non-parametric frequency estimation of the fundamental periodicity of a multi-frequency signal when a smaller number of periods are covered - up to two periods in the measurement time. The estimation procedure uses the weights of two Rife-Vincent I windows on the same set of acquired signal samples and then uses a combination of two consecutive DFT amplitude coefficients in the quotient. To reduce the harmonic influence, the technique of near-coherent frequency evaluation is used, and to reduce the interharmonic influence, a method can be added where the rest of the signal is averaged after determining the periodic part of the signal. The simulation and experimental results obtained show a very good compromise between fast and accurate estimation.
1 January 2011 in Metrology and Measurement Systems
Estimation of the Amplitude Square Using the Interpolated Discrete Fourier Transform: To improve the estimation of active power, the possibility of estimating the amplitude square of a signal component using the interpolation of the squared amplitude discrete Fourier transform (DFT) coefficients is presented. As with an energy-based approach, the amplitude square can be estimated with the squared amplitude DFT coefficients around the component peak and a suitable interpolation algorithm. The use of the Hann window, for which the frequency spectrum is well known, and the three largest local amplitude DFT coefficients gives lower systematic errors in squared interpolated approach or in better interpolated squared approach than the energy-based approach, although the frequency has to be estimated in the first step. All investigated algorithms have almost the same noise propagation and the standard deviations are about two times larger than the Cramér-Rao lower bound.
1 April 2006 in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
The paper presents effective algorithms for fast measurement and estimation of the unknown changing frequency and amplitude. The method for emulating coherent sampling with changing signal parameters by the interpolation of the DFT to estimate the frequency and amplitude of the particular component is described. An analysis of errors of the DFT coefficients caused by the frequency variation shows that the errors have two systematic contributions: the bias part due to the window spectrum main lobe and the long-range contribution. They can be both reduced with the interpolation. The optimum for reducing the time of measurement to two periods of the fundamental component and simultaneously reducing the influences of the harmonic components as possible can be the estimation with the two-point interpolation and the Manning window