A partial shading condition (PSC) is one of the most common problems in the photovoltaic (PV) system. It causes the output power of a PV system drastically decrease. Meta-heuristic algorithms (MHA) can track the maximum power point in a power-voltage (P-V) curve with multiple peaks. Grey wolf optimization (GWO) algorithm is a new optimization algorithm based on MHA. It has been used to solve optimization problems in many applications including MPPT for a PV system. However, the accuracy and tracking time in the original GWO (OGWO) can still be further improved for various PSCs. Therefore, there have been some modified grey wolf optimization (MGWO) algorithms proposed to improve the GWO. Nevertheless, only incremental improvement has been made. Therefore, a modified GWO, named enhanced grey wolf optimization (EGWO) is proposed in this paper. The proposed method adds the weighting average, the pouncing behavior and nonlinear convergence factor in the OGWO. In particular, since real wolves may engage in pouncing action when they are hunting, inclusion of pouncing completes the GWO algorithm and yields great improvements. As will be shown via simulation and experiment, the EGWO can drastically reduce the tracking time (up to 45.5% of the OGWO) and the dynamic tracking efficiency can be improved by more than 2%, compared to the OGWO. Moreover, the EGWO achieves the highest maximum power point compared to some of the existing GWO and other swarm based algorithms.
2 March 2020 in IEEE Transactions on Industry Applications
Four-wheel independent drive is an important research topic for the future development of pure electric vehicles due to its fast response and great flexibility of path tracking. One of the critical issue is to maintain the vehicle motion stability of the four-wheel independent drive electric vehicle (4WID EV) by appropriately distributing the torque of each wheel. The paper presents a hierarchical control structure to counteract the stability problems caused by the actuator faults and road friction uncertainties. Instead of using linear control at the top-level (i.e. the outer control loop), a novel sliding mode controller with adaptive PI sliding surface is designed to achieve the required virtual control signal. For the bottom-level controller (or the inner loop controller), dynamic control allocation is employed to optimally allocate the required actual torque for each wheel. The stability of the overall closed-loop system is successfully achieved and proved by using the Lyapunov method. The proposed controller has been tested via simulation and experiments with various actuator faults and road conditions. All the test cases showed the superiority of the proposed method compared to some of the currently existing 4WID control strategies.
Solar modules under partial shading (PS) conditions will result in power and voltage characteristic curves (P-VCC) having multiple peaks. If the maximum power point cannot be obtained, the output power of the solar modules will be greatly reduced. Hence, there have been various maximum power point tracking (MPPT) control methods developed to address this problem. One alternative is to employ the meta-heuristic approach (MHA) to track the global maximum power point (GMPP). Recently, a new MHA called Bat Algorithm (BA) has performed well in the MPPT. Nevertheless, BA may fail to track the GMPP when there are some local maximum power points (LMPPs) close to the GMPP. Also, the tracking time needs to be further reduced to accommodate rapidly changing irradiance. Therefore, a combination of BA with the abandonment mechanism of Cuckoo Search (CS) is proposed to improve the tracking performance of the BA. Both simulation and experimental results show that the proposed method, as compared to BA, yields better accuracy and an improvement of convergence speed of about 35% for various P-VCCs can be achieved. Moreover, the MBA has also been tested against some of the state-of-the-art MPPT algorithms such as Particle Swarm Optimization and Grey Wolf Optimization (GWO), and the results showed the superiority of the proposed method.
The displacement of synchronous generators by converter interfaced energy renewable resource essentially reduces the system inertia, which can trigger under-frequency load shedding relay. To support the frequency containment, virtual inertia control (VIC) and fast frequency control (FFC) based on energy storage system (ESS) have been developed. Most of the existing VIC did not take into account the power constraints of the ESS. Although some of the FFC methods account for the ESS constraints, they ignore the intermediate steady-state (ISS) operating point of the primary frequency response (PFR). To counteract these problems, a model predictive control (MPC) based FFC, which considers the power limitations of the ESS, the frequency deviation constraint, and the ISS frequency tracking capability, is proposed in this paper. The proposed MPC only requires few local measurements, and the system parameters including inertia constants, onset time of inertia response and the ISS time of the PFR can be accurately estimated. To achieve the optimal control action and reduce computational burden, quadratic programming (QP) is incorporated in the proposed MPC. The proposed MPC is tested on a real Taiwan power system. The fast response and robustness of the proposed MPC has been justified by comparing with the state-of-the-art method.
18 October 2022 in IEEE Industrial Electronics Magazine
The increasing grid penetration of renewable energy generation, energy storage, and controllable electronic loads [e.g., electric vehicle (EV) chargers, motor drives, and electrolyzers) is making power electronic converters (PECs)—their controllable grid connection interfaces—omnipresent. Therefore, fleets of PECs are becoming key players not only in coordinating the generation and storage but also in unlocking the potential for flexibility within each load. In this article, we discuss how cloud-based platforms and edge devices can allow for interfacing PECs and advanced control algorithms. We present seven different study cases using our own developed cloud-based platform that demonstrate the smart coordination of PECs in a variety of prototypes and real-world solutions. Moreover, the capabilities of cloud and edge computing are highlighted throughout the article at large, effectively characterizing cloud-based control of fleets of PECs as an essential part of the future energy sector.
22 November 2023 in IEEE Transactions on Energy Conversion
The paper proposes a day-ahead scheduling framework with a novel multi-stage battery degradation modeling method for an electric vehicle (EV) fast charging station (FCS) equipped with a battery energy storage system (BESS). Unlike previous studies, which employ a single battery degradation model to represent the aging process, this paper proposes a novel multi-stage battery degradation modeling method to accurately capture the degradation process across the whole lifespan. Subsequently, the multi-stage model is explicitly integrated into the proposed adaptive optimization framework in a computationally tractable way, thus having important practical implications in the field. The paper provides case studies to demonstrate the effectiveness of the proposed modeling method on a selected cycle aging model in reducing the operation cost of FCS with BESS operating in different stages. As a result, the overall operation cost with the multi-stage model is around 2.1 $\%$ on average lower than the single-stage model counterpart. In addition, results show that with the increasing number of divided stages, the model error decreases and becomes stable, while the reduced operation cost compared with the single-stage model increases and saturates. Finally, we apply the multi-stage framework considering other conventional degradation models to show the superiority of the proposed method.