Mazen Soliman

Mazen Soliman

Auto-generated profile, based on publicly available information

Mazen Soliman

ECE Department, Carnegie Mellon University, Pittsburgh, PA 15213 USA. He is now with Apple Inc.

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 March 2019 in Journal of Microelectromechanical Systems
Verified
Journal Article
Closed access
AKAbhay Kochhar
Abhay Kochhar
MGMary E. Galanko
Mary E. Galanko
MSMazen Soliman
Mazen Soliman
HAHoda Abdelsalam
Hoda Abdelsalam
LCLuca Colombo
Luca Colombo
GPGianluca Piazza
Gianluca Piazza
This paper reports a practical demonstration of a proposed resonant microelectromechanical receiver for low power wake-up receiver (WuRx) applications. The proposed system is made of three main components: a piezoelectric based acoustic resonator, an electrostatically-driven MEMS resonant demodulator, and a CMOS baseband trigger circuit. The filtering, amplification, and demodulation of the incoming signal are performed through the piezoelectric resonator and the resonant demodulator, ensuring zero power consumption for both the radio frequency (RF) and mixing stages. The only power consumption occurs at baseband by operating the CMOS circuit in deep subthreshold. This system utilizes a lithium niobate piezoelectric resonator possessing a figure of merit of around 650 and achieving voltage gain of 28 dB. A resonant demodulator fabricated in the Epi-Seal MEMS process is utilized to attain a conversion efficiency of 13.8 nA/V². In the trigger circuit, an amplifier with transimpedance >200 MΩ is utilized to sense the output current from the demodulator. An intermediate buffer and a multiple stage passive latch rectifier are utilized to generate the wake-up signal through a Schmitt trigger. The demonstrated system achieves -40.2 dBm sensitivity for a 44 kHz amplitude-modulated 50 MHz RF signal while consuming 38.75 nW. This architecture is a promising step toward a WuRx capable of achieving higher interference rejection, high sensitivity, and nW range power consumption at a high data rate. [2018-0261]

29 July 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
MSMazen Soliman
Mazen Soliman
AKAbhay Kochhar
Abhay Kochhar
HAHoda Abdelsalam
Hoda Abdelsalam
Flavius PopFlavius Pop
Flavius Pop
GVGabriel Vidal-Álvarez
Gabriel Vidal-Álvarez
JPJeyanandh Paramesh
Jeyanandh Paramesh
This work demonstrates a low-power wake-up receiver utilizing a MEMS resonant device followed by CMOS demodulator and rectifying trigger circuits. The MEMS device is a Lamb wave piezoelectric-based acoustic resonator utilizing a thin film of lithium niobate (LN) which possess the largest reported electromechanical coupling factors (kₜ²). This parameter, in conjunction with the high Q, is of paramount importance in providing for passive voltage amplification and filtering of the input signal. The CMOS demodulator is a 9-stage differential cross-coupled passive rectifier circuit designed with a differential output. It demodulates the signal from the MEMS resonator with the same gain as that could be achieved by a single-ended rectifier, but with half the charging time for double the single-ended bit-rate. The rectifier's output is AC-coupled and fed to a two-stage differential voltage amplifier. Finally, an active latch rectifier is used to trigger a wake-up signal. The wake-up receiver is tested with an on-off keying modulated signal with carrier frequency around 400 MHz achieving a bit rate up to 100 kbps. This newly proposed system exhibits a sensitivity of -47 dBm at 3 kbps while consuming a total power of 18 nW.