8 April 2019 in Sustainable Energy & Fuels
We focused on the low-temperature fabrication (∼100 °C) of nanoparticle-based NiOx hole transport layers for organic solar cells. We used high molecular weight polyethylene oxide (PEO) as a sacrificial additive for the processing of NiOx nanoparticle (NP) dispersions which is removed from the film by oxygen plasma prior to the active layer deposition. Through comprehensive characterization by optical, electrical and scanning probe techniques we show that an optimal NiOx : PEO ratio allows to disperse the NPs, hindering their aggregation and maximizing device performance. Finally, we demonstrate the practical relevance of our approach by inkjet printing the NiOx:PEO blends to produce hole transport layers (HTLs) for P3HT:PCBM bulk heterojunction solar cells with comparable efficiencies to devices produced with high-temperature precursor-based approaches. The utilization of P3HT:PCBM as active layer material is meant to offer an optimum standard for the introduction of the presented HTL processing approach and its applicability to a wider range of hybrid systems and multilayer optoelectronic devices.
30 November 2020 in Advanced Electronic Materials
LRLuis Arturo Ruiz‐Preciado
Luis Arturo Ruiz‐Preciado
Organic photodiodes (OPDs) are optical sensors combining high performance, lightweight mechanical flexibility, and processability from solution. Their fabrication by industrial printing techniques opens a wide range of innovative applications for emerging fields in sensing and the Internet of Things. They typically consist of printed multilayers with functionalities to absorb light, to extract charges, or to reduce detection noise. However, the printing of such device architecture poses a challenge as the deposition of a material can lead to disruption of film morphology or intermixing of materials if its solvent interacts with the previously deposited layer. This work proposes a process to print multilayers from the same solvent system utilizing the aerosol‐jet technique. By fine adjustment of the aerosol properties through the tube temperature (TTube), the drying time of poly(3‐hexylthiophene‐2,5‐diyl) (P3HT) printed layers is significantly reduced. This allows its deposition onto a P3HT‐based bulk‐heterojunction (BHJ) without negatively affecting its performance. The additional printed P3HT layer, spatially extends the donor region of the BHJ, providing ideal hole extraction and simultaneous noise reduction by the blocking of injected electrons. This donor blocking layer (DBL) yields a noise reduction of two orders of magnitude in OPDs operated under −2 V reverse bias.
1 November 2017 in Organic Electronics
DAD. Leonardo Gonzalez Arellano
D. Leonardo Gonzalez Arellano
+5