In this paper a regenerative braking energy recovery control strategy for electric vehicle (EV) based on fuzzy logic control is proposed. By analyzing the characteristic and the influence factors of the regenerative braking, the sugeno fuzzy logic controller (FLC) is established. Under assurance of braking safety and stability, the strategy distributes regenerative braking force and frictional braking force reasonably during braking, to make use of regenerative braking characteristic of motor as much as possible, so that much more kinetic energy can be converted into electric energy and stored in the battery. Model based on fuzzy logic control was established under the Matlab/Simulink environment and embedded into simulation software ADVISOR. Simulation experiments with different driving cycles were carried out, and the feasibility and effectiveness of fuzzy logic control strategy is tested with the state of charge (SOC) and braking energy recovery.
This paper presents a new frequency compensation approach for three-stage amplifiers driving a pF-to-nF capacitive load. Thanks to the cascode Miller compensation, the non-dominant complex pole frequency is extended effectively, and the physical size of the compensation capacitors is also reduced. A local Q-factor control (LQC) loop is introduced to alter the Q-factor adaptively when loading capacitance CL varies significantly. This LQC loop decides how much damping current should be injected into the corresponding parasitic node to control the Q-factor of the complex-pole pair, which affects the frequency peak at the gain plot and the settling time of the proposed amplifier in the closed-loop step response. Additionally, a left-half-plane (LHP) zero is created to increase the phase margin and a feed-forward transconductance stage is paralleled to improve the slew rate (SR). Simulated in 0.13-µm CMOS technology, the amplifier is verified to handle a 4-pF-to-1.5-nF (375× drivability) capacitive load with at least 0.88-MHz gain-bandwidth (GBW) product and 42.3° phase margin (PM), while consuming 24.0-µW quiescent power at 1.0-V nominal supply voltage.
This paper introduces the Extended Kalman Filter (EKF) to realize high dynamic tracking of GPS signal. It's compared with the traditional tracking loop with a third-order phase-locked loop (PLL), which is assisted by a second-order frequency-locked loop (FLL) and a second-order delay-locked loop (DLL). It can estimate carrier phase, Doppler shift, rate of change of Doppler shift and code phase in real-time for higher dynamics. The results of simulation show that the new tracking method can not only improve the dynamic acceleration as high as 100g, also improve the tracking accuracy.