DC/DC converter is widely used in power electronic applications as a critical part of power supply. During operation, component parameters of the DC/DC converter gradually degrade subjected to various environmental stresses. When they degrade to deviate from the normal value, soft faults will occur and directly affect the functionality and reliability of the whole system. To identify these anomalies effectively, a novel soft fault detection and diagnosis method based on contrastive learning is proposed for a DC/DC Buck converter. First, the output voltage ripples of the converter under healthy and faulty conditions are collected. Then, a feature representation of the voltage ripple is obtained through hierarchical contrastive learning at temporal-level and instance-level. Based on the learned representation, a support vector machine classifier is established to detect and locate soft faults. The proposed method does not need extra hardware or signal injection, thereby reducing the cost and complexity. Simulation and physical experiment results verify the effectiveness and robustness of the proposed method.
21 October 2020 in IET Control Theory & Applications
The capacitive current feedback active damping strategy has a limited damping region. When the grid‐side impedance is large, the digital control inductor–capacitor–inductor (LCL) grid‐connected inverter system with grid‐side current loop control and capacitive current feedback active damping cannot run stably. To address this issue, this study proposes an improved capacitive current feedback active damping strategy, namely the capacitive current fractional proportional–integral feedback strategy (CCFPIFS), which increases the upper‐frequency limit of the system damping region and approaches to the Nyquist sampling frequency. Furthermore, this study analyses the constraints of fractional‐order proportional–integral controller parameters to ensure the stability of the system. The simulation analysis is performed by Simulink. The experimental results are consistent with theoretical expectations. Consequently, the proposed CCFPIFS can not only achieve better control performance and improve the robustness of the LCL grid‐connected inverter system, but also improve the output power quality of the system. This damping strategy can make the LCL grid‐connected inverter system work stably under the environment of high grid impedance.