Michiel Steyaert

Michiel Steyaert

Auto-generated profile, based on publicly available information

Michiel Steyaert

Department of Electrical Engineering, KU Leuven, B-3001 Leuven, Belgium

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 April 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
ARAthanasios Ramkaj
Athanasios Ramkaj
MSMaarten Strackx
Maarten Strackx
MSMichiel S. J. Steyaert
Michiel S. J. Steyaert
FTFilip Tavernier
Filip Tavernier
This paper presents a 1.25-GS/s 7-b single-channel successive approximation register (SAR) analog-to-digital converter (ADC) that achieves a low input frequency SNDR/SFDR of 41.4/51 dB, while the SNDR/SFDR at Nyquist is 40.1/52 dB and remains still 36.4/50.1 dB at a 5-GHz input frequency (eighth Nyquist zone) without any calibration. The high and nearly constant linearity is enabled by an improved bootstrap circuit for the input switch, while the high sampling rate, the highest among recently published >34-dB SNDR single-channel SAR ADCs, is accomplished by a triple-tail dynamic comparator and a unit-switch-plus-cap (USPC) capacitive digital-to-analog converter (CDAC). To further enhance the ADC speed, the SAR logic operates in parallel to the comparator, eliminating its timing from the critical loop. The prototype chip in 28-nm bulk CMOS occupies a core area of 0.0071 mm² and consumes 3.56 mW from a 1-V supply, leading to a Walden figure-of-merit of 34.4 fJ/conversion-step at Nyquist.

7 January 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
ARAthanasios Ramkaj
Athanasios Ramkaj
JRJuan C. Pena Ramos
Juan C. Pena Ramos
MPMarcel J. M. Pelgrom
Marcel J. M. Pelgrom
MSMichiel S. J. Steyaert
Michiel S. J. Steyaert
MVMarian Verhelst
Marian Verhelst
FTFilip Tavernier
Filip Tavernier
This article presents a 5-GS/s 12-b passive-sampling 8x-interleaved hybrid analog-to-digital converter (ADC) that achieves a low-frequency SFDR/SNDR of 75.2/62.4 dB and a Nyquist SFDR/SNDR of 65.4/58.5 dB. A significant power reduction while attaining a bandwidth in excess of 6 GHz and a high spectral purity are enabled by: 1) an on-chip terminated very fast settling buffer-less input front end; 2) an on-chip clock chain with as low as 11-fs added jitter; 3) an asynchronous three-stage pipelined-successive approximation register (SAR) sub-ADC; and 4) on-chip co-designed analog-digital calibrations deal with sub-ADC and time-interleaving (TI) artifacts to achieve the desired spectral performance levels. The 28-nm bulk CMOS prototype chip occupies a total area of 4.56 mmsuperscript2 with a core area of 1.76 mmsuperscript2 and consumes 158.6 mW from a 1-V supply, leading to the Nyquist figure of merits of Schreier (FoMS) and Walden (FoMW) of 160.5 dB and 46.1 fJ/conversion step, respectively.

18 August 2017 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
NBNicolas Butzen
Nicolas Butzen
MSMichel S. J. Steyaert
Michel S. J. Steyaert
In this paper, two techniques, called stage-outphasing (SO) and multiphase soft-charging (MSC), are introduced, which make use of the advanced multiphasing concept to soft-charge charge transfers between flying capacitors. As such, the charge sharing losses of fully integrated switched-capacitor (SC) converters are reduced, leading to better capacitance utilization, higher efficiency, and higher power density. Furthermore, when used in combination with the Dickson converter, the relative improvement gets better with increasing voltage conversion ratio (VCR), making them an excellent choice to reduce power delivery network-induced losses in modern microchips. The impact of the proposed techniques on the performance is discussed. A 3:1 Dickson SC converter is realized, which implements SO and MSC and achieves a state-of-the-art 1.1-W/mm2 power density and 82% efficiency combination using common capacitor technologies. Finally, two figures of merit for monolithic SC dc-dc converters are proposed that include the VCR and power density, to allow fair comparison of the converter’s performance to the literature.

20 October 2017 in IEEE Transactions on Nuclear Science
Verified
Journal Article
Closed access
JPJeffrey Prinzie
Jeffrey Prinzie
JCJorgen Christiansen
Jorgen Christiansen
PMPaulo Moreira
Paulo Moreira
MSMichiel Steyaert
Michiel Steyaert
PLPaul Leroux
Paul Leroux
This paper presents a radiation tolerant Phase-Locked Loop (PLL) CMOS ASIC with an optimized Voltage Controlled Oscillator (VCO) for Single-Event Upsets (SEUs). The circuit is designed for high-energy particle physics experiments for low-jitter clock generation and clock recovery. An optimal tuning strategy of the VCO is presented that minimizes the cross-section and the SEU sensitivity of the oscillator. The circuit is processed in a 65 nm CMOS technology and has been irradiated with heavy ions with an LET (Linear Energy Transfer) between 10 to 69.2 MeV.cm²/mg. A comparison has been made with a conventional oscillator which proves a significant improvement in SEU sensitivity.

25 December 2018 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
NBNicolas Butzen
Nicolas Butzen
MSMichiel Steyaert
Michiel Steyaert

1 December 2006
Verified
Conference Paper
Closed access
BSBert Serneels
Bert Serneels
MSMichiel Steyaert
Michiel Steyaert
WDWim Dehaene
Wim Dehaene
The design of a high speed, low voltage to high voltage level shifter in a digital 1.2 V, 0.13 mum CMOS technology is presented. The topology uses two differentially switched cascoded transistor ladders. The output signal has an offset of two times the nominal supply voltage of the used technology with respect to the input signal. Oxide stress and hot carrier degradation is minimized since all transistors of the level shifter operate within the voltage limits imposed by the design rules of a mainstream CMOS technology.