30 March 2017 in Studia Universitatis Babeș-Bolyai Chemia
Biogas production by anaerobic digestion of residual waters from different sources (a treatment plant and a beer factory) was investigated in laboratory small scale batch reactors. Both wastewaters represent efficient biogas substrates. As concern the methane composition, the value is slightly higher in the case of biogas produced by anaerobic digestion of wastewater from beer factory. In the second part of this study, anaerobic co-digestion of wastewater and cow whey was performed. Addition of cow whey to wastewater from beer factory increase the biogas yield, while the addition of cow whey to wastewater from treatment plant decrease the biogas yield. In both cases of co-digestion, the methane content in biogas was higher than in the single digestion processes.
1 June 2013 in Advanced Engineering Forum
GDGabriela Alina Dumitrel
In present times, replacing fossil fuels with renewable ones becomes a problem more and more stringent in the existing society. Related with this topic, biogas production, as one of the potential renewable fuels has an increasing role both at regional and global level in relation to the potential it poses for energetic independence, both for developed and in course of development countries. The present article intends to underline the potential usage of agricultural biomass (namely wheat bran and cereal mix) as renewable source of energy for biogas production. Factorial design of experiments was employed to study the effect of two factors (net calorific value and C/N ratio) on total biogas produced after 65 days of anaerobic digestion. Main effects and interaction effects of these factors were analyzed using statistical techniques. A regression model was obtained to predict the total biogas production and it was found to adequately fit the experimental range studied.
20 March 2020 in Studia Universitatis Babeș-Bolyai Chemia
This study shows the results of preliminary monitoring of particulate matter (PM10 and PM2.5) at four measurement points, during the three campaigns (spring, autumn, winter) The study was conducted for the first time in residential area near coal-fired power plant, Ugljevik, Bosnia and Herzegovina. The power plant flue gas cleaning equipment in the time of this research was out of the function. Authors investigated seasonal variations of PMs concentration levels, influence of terrain structure and meteorological condition on PMs distribution and identification of PMs origin sources. The results revealed that seasonal variation was more expressed in the case of PM2.5 concentration, while for PM10, occasionally episodic pollution (399µg/m³) was recorded. Also, it was noted that prevailing meteorological conditions and surrounding terrain structure could have limiting effect on PMs dispersion. In order to detect PMs origin, linear regression analysis was applied. Authors revealed that PM2.5 originating from power plant could be prescribed partly for M1 where the greatest correlation was calculated (R2=0,45). Although the measuring sites were set in proper position regarding dominant winds and terrain structure, it was identified that certain measurement sites were affected by the other local particulate matter sources, especially in case of PM10.
28 September 2018 in Studia Universitatis Babeș-Bolyai Chemia
Nowadays the need for renewable resources becomes more and more stringent. Biomass remains one of the most important sources of energy, being used directly or by chemical conversion processes in order to produce clean energy. Relative to this aspect, the present paper proposes the direct approach, by analyzing to biomass type materials (topinambur and Romanian hemp) in order to determine their physical and chemical characteristics and their potential use in combustion processes.
30 March 2022 in Studia Universitatis Babeș-Bolyai Chemia
DDDan Cristian Danielescu
The main environmental problems of pulp and paper production are water consumption, pollutant fillings of effluents (biogenic and refractory organic compounds, suspended solids, colloids, toxic inorganic compounds). This industry is obliged to minimize its impacts on the aquatic environment and at the same time, due to huge water consumption, must adopt strategies for sustainable use of water resources, in the context of ensuring European requirements for integrated pollution prevention and control and implementation of the Framework Directive of water. The original experimental research refers to the improvement of the efficiency of conventional physicochemical treatment of residual effluents from the pulp and paper industry by using new prehydrolysed coagulation-flocculating agents. This stage is preliminary to the advanced effluent treatment stage, for its recirculation in the technological process. Correlating these structures with the efficiencies obtained in coagulation, it is noted that the low coagulant doses of PAC-1 and PAC-2 compared to SA, are due to the existence of more active polymeric species of Al₁₃⁷⁺ or Al₃₀¹⁸⁺, with higher load and molecular weight than in the case of aluminium monomeric species formed in the use of aluminium sulphate. There are high efficiencies for removing turbidity between 98-99% as well as organic loading of about 70% for the three coagulants studied (SA, PAC-1, PAC-2), but for the same efficiencies the doses of SA were double or even triple those required for PAC-1 and PAC-2.