Carrier-transport mechanisms are studied in high-purity diamond irradiated with 6 MeV electrons in the dose range of 1012–1016 cm−2 and annealed at different temperatures up to 1450 °C. Lifetimes and diffusion coefficients are extracted using two pump–probe techniques based on free-carrier absorption and transient-grating principles and then correlated with the corresponding defect evolution from spectroscopic measurements. The neutral monovacancy is revealed as the main carrier recombination center in the as-irradiated diamond, providing bipolar carrier lifetimes of a few nanoseconds at the highest irradiation dose. Carrier-capture cross sections are reduced during annealing as vacancies aggregate into divacancies at ≤1000 °C and extended vacancy clusters at 1450 °C.
An optical pump–probe technique was used to detect spatial distribution of carrier lifetimes across the thickness of a high-quality diamond device structure. Two samples with as-received and boron implanted surfaces were compared to assess the role of implantation and related processing on carrier recombination mechanisms. It was found that the two implanted surfaces show very different behaviors despite undergoing the same treatment. At one of the surfaces, carrier lifetimes remained relatively unchanged, indicating surface recombination rates in the 102–103 cm/s range. At the other surface, carrier lifetimes were almost a magnitude lower and correlated with the locally detected nitrogen vacancy defect that was attributed to the elevated concentration of residual nitrogen.
1 January 2015 in High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
Ti−Al−N coatings were applied by the reactive magnetron sputtering method at different deposition parameters (substrate temperature, bias voltage, and reactive gas flow). The structure and elemental composition of films were determined by the scanning electron microscopy and energy dispersive X-ray analysis, respectively. The thermal stability of Ti−Al−N coatings was studied by the Raman spectroscopy after annealing in air at various temperatures (550°C, 650°C, and 750°C). It was found that the selection of appropriate deposition parameters allows one to obtain Ti−Al−N coatings with improved thermal stability.
1 March 2016 in Journal of Engineering Physics and Thermophysics