7 March 2025 in IEEE Sensors Journal
Capacitive sensing circuit is one of the key technologies in the development of a series of deep space exploration instruments, such as inertial sensors in space gravitational wave detection mission and seismometers in planetary / lunar exploration programs. Space exploration missions require high precision, low-power and high-reliable capacitive sensing circuits. Although the traditional bridge-based capacitive detection circuits widely used currently behave high accuracy, they have a relatively complex structure and higher power consumption. In this paper, a charge-discharge differential capacitive sensing circuit based on high stability square-wave generator, ring-diode switch and low noise trans-impedance amplifier is proposed and investigated systematically. The system noise model is presented based on detailed analysis and measurement of the main noise sources. Low noise design optimization scheme is proposed based on the noise model. A prototype circuit is developed and tested. The sensitivities with several different excitation frequencies are calibrated. The measured noise is compared to the theoretical model and demonstrates a good consistency. The experimental results show that the noise equivalent capacitance resolution of this circuit reaches 0.24 aF/Hz1/2 at 0.1 Hz and 0.028 aF/Hz1/2 at 100 Hz. Benefitting from its simple structure and high measurement accuracy, it is highly suitable for space exploration instruments and other applications.
24 March 2025 in IEEE Transactions on Instrumentation and Measurement
High-precision inertial sensors are key instruments in many space science missions, and need to be verified on the ground to ensure that they operate reliably in orbit with the designed accuracy. However, for inertial sensors with accuracy of 10-10 m/s2 or even higher, traditional calibration method put forward higher requirements for facilities and environment, and the test precision level is usually limited by seismic noise. In this study, an electromagnetic excitation calibration method of high-precision inertial sensors is proposed and experimentally verified. The active controlled four-wire pendulum provides a low-noise ground test bench. The driving force required for calibration is generated by the non-contact electromagnetic actuator, which drives the bench to move along the calibration direction. A high-precision electrostatic accelerometer and two commercial seismometers are used for experimental testing and comparison. The experimental results show that the proposed method can realize the sensitivity coefficient calibration, amplitude-frequency response calibration, and resolution calibration of the highvoltage levitation electrostatic accelerometer. The uncertainty of the sensitivity calibration is evaluated to be 0.07%, and the resolution is evaluated to be 2.8×10-10 m/s2 at 0.5 Hz. This work provides a new high-precision dynamic performance test facility for high precision inertial sensors.
30 October 2025 in Measurement
1 January 2026 in IEEE Transactions on Instrumentation and Measurement