7 June 2022 in IEEE Transactions on Microwave Theory and Techniques
In this article, a load-modulation enhanced wideband compact high-efficiency millimeter-wave (mm-wave) gallium nitride (GaN) monolithic microwave integrated circuit (MMIC) synchronous Doherty power amplifier (DPA) is presented. A synchronous DPA architecture is used to ensure the optimal saturation performance at the mm-wave band. Based on the analysis of load-modulation behavior, the bandwidth of the DPA can be extended by decreasing the phase dispersion factor $\alpha $ . A simple optimal tuning-based method is proposed to design an equivalent $\lambda $ /4 transmission line (EQWTL) with the minimal $\alpha $ for a given topology. Furthermore, the influence of the power division ratio $\sigma $ on the proposed DPA’s load-modulation behavior has also been analyzed and a proper load modulation can be realized by splitting more power to the peaking branch properly. For verification, a 24–28-GHz GaN MMIC synchronous DPA has been designed using a 0.15- $\mu \text{m}$ GaN on silicon carbide high-electron-mobility transistor process. Both the load modulation and the matching of the fundamental and the second harmonic load impedances can be realized by a modified bandpass-type EQWTL with a minimal $\alpha $ easily. Experimental results show that the fabricated DPA can achieve the output power of 35.4–36 dBm and the power-added efficiency (PAE) of 27.8%–36.8% at saturation. The PAE at 6-dB power back-off (PBO) is 18.3%–30.1% and the 9-dB PBO PAE is higher than 14.3% in the whole frequency band. An average PAE of 27.4% with good linearity is obtained when excited by a 400-MHz modulated signal after linearization.
28 July 2014 in IEEE Transactions on Microwave Theory and Techniques
This paper presents a low-power low-cost 45-GHz on-off keying (OOK) transceiver system in 90-nm CMOS for high-speed short-range wireless communications. The system includes a transmitter (Tx), a receiver (Rx), and two on-board substrate integrated waveguide fed Yagi-Uda antennas. The Tx provides about 7 dBm of output power and better than 50-dB on/off isolation while consuming 61.6 mW of dc power. The Rx performs noncoherent demodulation with a power consumption of 53.6 mW. The on-board antennas are integrated with the Tx and Rx using carefully designed broadband wire-bond interconnections, resulting in a low-cost system integration. The proposed transceiver achieves error-free operation (bit error rate <;10-2) of 4-Gb/s data rate over a distance of 55 cm, which results in a bit energy efficiency per distance (BEEPD) of 0.52 pJ/bit/cm. To our best knowledge, this work shows the highest on/off isolation among the OOK Txs, the longest transmission distance, and the best BEEPD among the OOK transceivers reported to date in the millimeter-wave frequency band.
26 April 2017 in IEEE Microwave and Wireless Components Letters
This letter proposes a broadband high isolation and high power compact single pole double throw (SPDT) switch. In contrast to the traditional structure of grounded source pad, the source pad of the shunt-stacked FET is absorbed into the transmission line, and the drain of the shunt-stacked FET is grounded to a via-hole. This structure helps to extend the operation bandwidth and reduce the chip size. The proposed SPDT switch is composed of six shunt-stacked FET units on each branch with this novel structure. Stacked FETs technique increases the voltage handling by placing two FETs in series. It has been fabricated using a commercial 0.1 μm GaAs pseudomorphic high-electron-mobility transistor (PHEMT) process. The chip size is 1.2x0.8 mm². The switch operates at the frequency range of 35-70 GHz with less than 3 dB insertion loss and more than 40-dB isolation. The switch demonstrates a 1 dB insertion loss compression with a 20.2 dBm input power at 31 GHz. The isolation is larger than 30 dB from 10 to 95 GHz. To the best of the authors' knowledge, this broadband isolation performance is among the best of the reported SPDT switches.
2 January 2023 in IEEE Microwave and Wireless Technology Letters
This letter presents a 2.2–4.2-GHz 360 $^{\circ}$ continuous-tuned phase shifter (PS) using the Gallium arsenide (GaAs) heterojunction bipolar transistor (HBT) technology. A new method for broadband analog PS design based on a tunable low-pass network (LPN), a tunable high-pass network (HPN), and a magnetically coupled all-pass network (MCAPN) configuration is proposed to achieve uniform phase shifting and flat amplitude response at the same time for each phase-shifting state. The fabricated PS demonstrates a low average insertion loss (IL) of 4.9 dBC a low root-mean-square (rms) phase error of less than 5.5 $^{\circ}$ , and a low rms amplitude error of less than 0.47 dB between 2.2 and 4.2 GHz. The proposed analog PS has the most flattened phase performance compared with previously reported pass PSs over a wide bandwidth.
26 February 2026 in IEEE Solid-State Circuits Letters
This paper presents a novel fourth-order single-voltage-controlled (SVC) tunable monolithic microwave integrated circuit (MMIC) bandpass filter (BPF) for tunable filter bank applications. Utilizing the tapped inductor technique (TIT), the proposed filter achieves compact magnetic coupling with reduced loss, avoiding the use of bulky inductor-or transformer-based coupling structures. The filter demonstrates a continuous tuning range from 1 GHZ to 1.7 GHz with approximately 60% fractional bandwidth (FBW), while maintaining a consistent insertion loss (IL) of 4.55 ± 0.25 dB. A high out-of-band rejection of 45 dB up to 30 GHz [17.6 times center frequency (fcen)] is also achieved. These performances promise significant application potential for tunable filter banks.