The photon count rate (PCR) of superconducting single-photon detectors made of films shaped as a 2--wide strip and a 115-nm-wide meander strip line is studied experimentally as a function of the dc biasing current at different values of the perpendicular magnetic field. For the wide strip, a crossover current is observed, below which the PCR increases with an increasing magnetic field and above which it decreases. This behavior contrasts with the narrow meander, for which no crossover current is observed, thus suggesting different photon-detection mechanisms in the wide and narrow strips. Namely, we argue that in the wide strip the absorbed photon destroys superconductivity locally via the vortex-antivortex mechanism for the emergence of resistance, while in the narrow meander superconductivity is destroyed across the whole strip line, forming a hot belt. Accordingly, the different photon-detection mechanisms associated with vortices and the hot belt determine the qualitative difference in the dependence of the PCR on the magnetic field.
28 June 2021 in Superconductor Science and Technology
We report our study of detection efficiency (DE) saturation in wavelength range 400–1550 nm for the NbN superconducting microstrip single-photon detectors (SMSPDs) featuring the strip width up to 3 µ m. We observe an expected decrease of the DE saturation plateau with the increase of photon wavelength and decrease of film sheet resistance. At 1.7 K temperature DE saturation can be clearly observed at 1550 nm wavelength in strip with the width up to 2 µ m when sheet resistance of the film is above 630 Ω sq −1 . In such strips the length of the saturation plateau almost does not depend on the strip width. We used these films to make meander-shaped detectors with the light sensitive area from 20 × 20 µ m 2 to a circle 50 µ m in diameter. In the latter case, the detector with the strip width of 0.49 µ m demonstrates saturation of DE up to 1064 nm wavelength. Although DE at 1310 and 1550 nm is not saturated, it is as high as 60%. The response time is limited by the kinetic inductance and equals to 20 ns (by 1/ e decay), timing jitter is 44 ps. When coupled to multi-mode fibre large-area meanders demonstrate significantly higher dark count rate which we attribute to thermal background photons, thus advanced filtering technique would be required for practical applications.
High sensitivity imaging at the level of single photons is an invaluable tool in many areas, ranging from microscopy to astronomy. However, development of single-photon sensitive detectors with high spatial resolution is very non-trivial. Here we employ the single-pixel imaging approach and demonstrate a proof-of-principle single-pixel single-photon imaging setup. We overcome the problem of low light gathering efficiency by developing a large-area microstrip superconducting single photon detector coupled to a multi-mode optical fiber interface. We show that the setup operates well in the visible and near infrared spectrum, and is able to capture images at the single-photon level.
We experimentally study timing jitter of single-photon detection by NbN superconducting strips with width ranging from 190 nm to . We find that timing jitter of both narrow (190 nm) and micron-wide strips is about 40 ps at currents where internal detection efficiency saturates and it is close to our instrumental jitter. We also calculate intrinsic timing jitter in wide strips using the modified time-dependent Ginzburg-Landau equation coupled with a two-temperature model. We find that with increasing width the intrinsic timing jitter increases and the effect is most considerable at currents where a rapid growth of changes to saturation. We relate it with complicated vortex and antivortex dynamics, which depends on a photon’s absorption site across the strip and its width. The model also predicts that at current close to depairing current the intrinsic timing jitter of a wide strip could be about ( is a critical temperature of superconductor), i.e., the same as for a narrow strip.
We report the development of photon-number-resolving superconducting single-photon detector with micron-scale strips. The detector is designed as serial meander-shaped strips with resistors connected in parallel to each strip. We investigate the performance of the detectors comprising of 5–14 strips with the widths in the range – and covering an area as large as making it feasible for coupling to multimode fibers. We demonstrate resolution of up to six photons and analyze the sources of errors in photon-number resolution.
1 July 2025 in Superconductor Science and Technology
This work demonstrates that depositing a thin layer of Mo (5–15 nm) onto a 10 nm thick NbN strip leads to a significant increase in the nonlinearity of the kinetic inductance . Specifically, the change in with increasing current reached 70% in the NbN/Mo bilayer at liquid helium temperature, whereas in the NbN strip, changed by only 10% in the superconducting state. In addition to altering the nonlinear properties, the Mo layer caused a significant increase in the critical current at low temperatures (up to 2 times in the case of a 5 nm thick Mo layer). The increased nonlinearity of can be explained by two factors: (i) a reduction of the critical supervelocity at which the superconducting state becomes unstable when a Mo layer is deposited on NbN, and (ii) a higher sensitivity of the induced superconductivity in Mo to supervelocity/supercurrent. Considering the results on the transport properties of SN bilayers with a high ratio of layer resistivities , it can be concluded that depositing a thin layer of a relatively low-resistivity metal onto a superconductor with high is a practical method for achieving a large nonlinearity of the superconductor’s kinetic inductance.