1 December 2023 in REM - International Engineering Journal
The geotechnical monitoring of tailings dams combined with a suitable application of geophysical electrical methods can improve their structure evaluation, allowing several correlations between direct analyses and the resistivity anomaly pattern. Considering this synergy, twenty-three electrical resistivity sections (ERT) were acquired along the beach, abutments, and central part of a dam, totalizing 10,776 m of dataset. After the interpretation of each ERT section, comparing the anomaly ranges with the water level meters measurements, three resistivity zones were defined: Zones of low resistivity ( 357 ohm-m), interpreted as dry zones, and regions with intermediate resistivity values, located between these limits. The groundwater surface generated from the interpretation of the electrical resistivity dataset and the groundwater surface acquired from the water level gauges were almost coincident. On the right abutment, the conductive anomalies showed remarkable continuity, suggesting a high moisture content in this region with strong gradients (200 mV) directed towards the zone of low resistivity values identified in the sections. The analysis showed a robust correlation of the ERT data with localized physical geotechnical measurements, valuable for monitoring dam integrity, overseeing the structure's response to climate and operational changes, and ultimately mitigating the risks of failure. The results of this study support the adoption of a seasonal 4D electrical resistivity survey as an effective tool to monitor and manage surface and high humidity zones, key indicators of dam integrity throughout the entire structure.
14 October 2022 in Anuário do Instituto de Geociências
Mining induced seismicity can expose tailings dams to ground motions with potential to trigger a failure, if the structure reaches a certain level of vibrations that could exceed the seismic coefficient design criteria from pseudostatic analysis. Despite the cited risk, mainly for dams that are closer to open pits, few dams in Brazil are monitored by microseismic systems, and there are no references in the literature about continuous seismic monitoring both in open pit (source) and tailings dam, which represents the motivation of this paper. A microseismic system was commissioned in Cajati Mine, São Paulo, to record seismic events continuously in an array of 16 geophones (14 Hz and 4.5 Hz), installed in boreholes near the open pit (12 sensors) and in the dam (4 sensors), has measured values of PGA (Peak Ground Acceleration) and PGV (Peak Ground Velocity) related to 2,972 induced events from rock removal in the open pit. During the period monitored, the total of 109 events have triggered sensors in both structures, producing 920 seismograms, with the highest values of PGA and PGV of 0.0135 m/s2 (0.1358% of g) and 0.0892 mm/s. The highest PGA value is 36 times lower than the vertical coefficient of 3% of g defined by Brazilian technical standard to dam design criteria, normally used in common pseudostatic analysis from geotechnical engineers. A routine microseismic monitoring brings a new set of valuable actionable data and information to support the management of geotechnical tailings dams’ risks, under the conditions of vibrations induced by mining production.
1 December 2018 in Journal of South American Earth Sciences