1 April 2024 in Physics of Fluids
Spherocylindrical particles encompass elongated spherical particles, such as biomass particles utilized in thermal reactions and capsule pills in the pharmaceutical industry, along with various other particles found in industrial production processes. Understanding the flow behavior of spherocylindrical particles within a spouted bed holds significant practical importance. This study delves into investigating the fluidization characteristics of spherocylindrical particles with varying aspect ratios within a spouted bed. Key parameters studied include particle void fraction, velocity, orientation, and mixing. These were analyzed using the computational fluid dynamics–discrete element method, and the simulation model's accuracy was verified through high-speed photography experiments. The findings revealed distinct void fraction distributions at different locations within the bed. Particles in the higher-bed region exhibited larger void fractions with flatter peaks compared to those in the lower-bed region. Moreover, the correlation between particle aspect ratio and void fraction varied at different heights within the bed. Notably, there was no significant correlation observed between particle aspect ratio and particle velocity. However, the larger the particle aspect ratio/gas velocity, the better the particle mixing quality. Additionally, gas velocity and particle aspect ratio had little effect on particle orientation, but there was a tendency for particle orientation angles to hover around 45°–60° near the wall region.
1 June 2024 in Physics of Fluids
Spouted bed is widely used in biomass combustion and other industrial production due to the advantages of good heat transfer performance and sufficient gas–solid mixing. In order to achieve higher heat and mass transfer performance and conversion efficiency, inert particles are often added to assist in the fluidization of biomass particles. However, the stacking patterns of different particles in a binary particle system can have some effects on particle flow, distribution, and bed stability. Therefore, in this study, the computational fluid dynamics–discrete element method was used to analyze the particle fluidization characteristics under four different particle stacking modes in a spouted bed. The results show that the average bed height of larger spherocylindrical particles is prioritized in binary particle systems. The void fraction of spherocylindrical particles tends to increase in the near-wall region, whereas spherical particles tend to decrease. When the binary particles are mixed at the initial moment, the change rule of vertical velocity of the two particles remains consistent. In addition, the vertical velocities of two kinds of particles when layered stacking is used are gradually close to each other only after a period of time. In addition, the orientation angle of the spherocylindrical particles in the spouted bed tends to be horizontal for both the single-component spherocylindrical particle system and the wall effect attenuates this phenomenon.
9 March 2026 in Soft Matter
Achieving controllable transport within chaotic active nematics remains challenging. By tuning surface anchoring (0°–90°), colloidal transport is regulated from directed migration to topological trapping, revealing distinct dynamic regimes.
1 July 2026 in Physics of Fluids
Surface anchoring plays a pivotal role in governing colloidal dynamics in active nematic fluids. This study numerically investigates the transport mechanisms of Janus particles with heterogeneous surface anchoring in a two-dimensional confined microchannel. The results demonstrate that in a pure active bath, +1/2 topological defects tend to pin at the anchoring junctions of the Janus particle, inducing topological polarization. This symmetry breaking effectively rectifies microscopic active stresses into macroscopic active driving forces and torques, achieving efficient spontaneous directional transport of the particle. In a Poiseuille flow, the particle transport is governed by the active-to-shear stress ratio. In the active-dominated regime, the synergy between chaotic vortices and asymmetric anchoring drives significant transverse near-wall migration of the particles. Simultaneously, constrained by the minimization of nematic elastic free energy and the dynamic balance of fluid-solid interfacial torques, the Janus particles exhibit an “orientational locking” tendency in the near-wall region. This effect prevents the particles from releasing local stresses through free continuous rotation, which exacerbates interfacial momentum dissipation and results in severe slip retardation and an anomalous dynamical feature of “high kinetic energy but low transport efficiency.” This study unravels the physical mechanisms underlying the use of surface topological asymmetry to induce active propulsion, shedding light on potential applications in regulating the transport of active matter.