A single-ended four-level pulse-amplitude modulation (PAM-4) transmitter (TX) for memory interfaces achieves high signal integrity by combining an impedance-matched PAM-4 driver with a three-point ZQ calibration scheme. This improves PAM-4 linearity by allowing the driver to compensate for its impedance variation caused by the change in the drain-source voltage (VDS) to suit the four output levels considering both the TX and the receiver (RX). Resistors and inductors are eliminated from the voltage-mode (VM) driver, reducing the area requirement. The two-tap asymmetric feed-forward equalization (FFE) allocates six different coefficients to each minimum pull-up and pull-down transition, compensating for nonlinear equalization strengths and asymmetric characteristics of the driver. A prototype chip fabricated in the 65-nm CMOS has an area of 0.0333 mm² and consumes 0.64 pJ/bit. It achieves a data rate of 28 Gb/s/pin with a ratio level separation mismatch (RLM) of 0.993.
The signal integrity of dual-rank LPDDR5 interface is challenged by reflections from the stub of the inactive rank within the redistribution layer (RDL). These reflections arrive at the active rank within the unit-interval of the data-rate and distort not only the post-cursor but also the pre-cursor of the signal that the decision feedback equalizer (DFE) cannot remove. We introduce a differentiating receiver that restores data through edge information to eliminate the reflective distortions, including the pre-cursor, and a transition-detecting DFE to address remaining inter-symbol interference. A prototype receiver, fabricated in a 65 nm CMOS process, eliminates pre-cursor distortion with a reflection flight time of 50 ps and 70 ps, at 8 Gb/s and 6.4 Gb/s, resulting in a wide horizontal margin at a bit-error-rate of 10 -12 . The energy efficiency is 0.80 pJ/bit at 8 Gb/s.
12 November 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
The dual-rank configuration is one of the parallelization methods to increase the memory capacity for mobile applications. However, the stub mainly composed of the redistribution layer causes resonance reflections and its reflection interval reaches the bit period, which distorts signal and limits the signal bandwidth. A single-ended duobinary transmitter that utilizes the reflection is presented for dual-rank mobile memory interfaces where reflections dominate. The reflection is included in the transfer function for duobinary modulation, which allows the transmitter to have a wide eye opening and high energy efficiency. Two-tap reverse feed-forward equalization and slew-rate control are used to support the duobinary modulation in combination with the reflection. A prototype chip fabricated in a 65 nm CMOS process has an area of 0.0378 mm 2 and consumes 1.24 pJ/bit. It is verified at data rates of 8, 9 and 10 Gb/s/pin where the flight time of the 9 mm stub is 55.6 ps.
12 August 2024 in IEEE Transactions on Circuits and Systems II: Express Briefs
This brief presents an on-chip bias temperature instability (BTI) monitor to accurately detect performance degradation caused by negative BTI (NBTI) and positive BTI (PBTI) in DRAM periphery. The proposed BTI monitor is capable of isolated measurement of both NBTI and PBTI using a configurable pull-up and pull-down switching network. The dual-delay line topology also ensures fast measurement to minimize unwanted BTI recovery, which reduces measurement accuracy. In addition, a calibration scheme for process variation is proposed using body biasing of devices that mimics BTI-induced stress to further enhance measurement accuracy.