Suhwan Kim

Suhwan Kim

Auto-generated profile, based on publicly available information

Suhwan Kim

Department of Electrical and Computer Engineering and the Inter-University Semiconductor Research Center (ISRC), Seoul National University, Seoul, South Korea

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 December 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YJYong-Un Jeong
Yong-Un Jeong
HPHyunkyu Park
Hyunkyu Park
CHChangho Hyun
Changho Hyun
JCJoohyung Chae
Joohyung Chae
SJShin-Hyun Jeong
Shin-Hyun Jeong
SKSuhwan Kim
Suhwan Kim
A single-ended four-level pulse-amplitude modulation (PAM-4) transmitter (TX) for memory interfaces achieves high signal integrity by combining an impedance-matched PAM-4 driver with a three-point ZQ calibration scheme. This improves PAM-4 linearity by allowing the driver to compensate for its impedance variation caused by the change in the drain-source voltage (VDS) to suit the four output levels considering both the TX and the receiver (RX). Resistors and inductors are eliminated from the voltage-mode (VM) driver, reducing the area requirement. The two-tap asymmetric feed-forward equalization (FFE) allocates six different coefficients to each minimum pull-up and pull-down transition, compensating for nonlinear equalization strengths and asymmetric characteristics of the driver. A prototype chip fabricated in the 65-nm CMOS has an area of 0.0333 mm² and consumes 0.64 pJ/bit. It achieves a data rate of 28 Gb/s/pin with a ratio level separation mismatch (RLM) of 0.993.

14 January 2010 in Lab on a Chip
Verified
Journal Article
Closed access
PDF file
BLByung Yang Lee
Byung Yang Lee
SSSung Min Seo
Sung Min Seo
DLDong Joon Lee
Dong Joon Lee
MLMinbaek Lee
Minbaek Lee
JLJoohyung Lee
Joohyung Lee
SHSeunghun Hong
Seunghun Hong
We developed a carbon nanotube (CNT)-based biosensor system-on-a-chip (SoC) for the detection of a neurotransmitter. Here, 64 CNT-based sensors were integrated with silicon-based signal processing circuits in a single chip, which was made possible by combining several technological breakthroughs such as efficient signal processing, uniform CNT networks, and biocompatible functionalization of CNT-based sensors. The chip was utilized to detect glutamate, a neurotransmitter, where ammonia, a byproduct of the enzymatic reaction of glutamate and glutamate oxidase on CNT-based sensors, modulated the conductance signals to the CNT-based sensors. This is a major technological advancement in the integration of CNT-based sensors with microelectronics, and this chip can be readily integrated with larger scale lab-on-a-chip (LoC) systems for various applications such as LoC systems for neural networks.

26 December 2007 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
SKSuhwan Kim
Suhwan Kim
CCChang Jun Choi
Chang Jun Choi
DJDEOGKYOON JEONG
DEOGKYOON JEONG
SKStephen V. Kosonocky
Stephen V. Kosonocky
SPSung Bae Park
Sung Bae Park
Power gating is one of the most effective techniques in reducing leakage power, which increases exponentially with device scaling. However, large ground bounces during abrupt changes of power mode may cause unwanted transitions in neighboring circuits, which should still be operating normally. We analyzed this ground-bounce noise and reduced it with novel power-gating structures that utilize holistic integrated device-circuit-architecture approaches. We control the amount of charge in the intermediate nodes of the circuit that passes through the sleep transistors during the wake-up transition and stabilize the minimum virtual power supply voltage required for data retention. These techniques have been proven in silicon using 65-nm bulk CMOS technology.

21 October 2010 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
DKDeok-Soo Kim
Deok-Soo Kim
HSHeesoo Song
Heesoo Song
TKTaeho Kim
Taeho Kim
SKSuhwan Kim
Suhwan Kim
DJDEOGKYOON JEONG
DEOGKYOON JEONG
A 0.3-1.4 GHz all-digital phase locked loop (ADPLL) with an adaptive loop gain controller (ALGC), a 1/8-resolution fractional divider and a frequency search block is presented. The ALGC reduces the nonlinearity of the bang-bang phase-frequency detector (BBPFD), reducing output jitter. The fractional divider partially compensates for the large input phase error caused by fractional-N frequency synthesis. A fast frequency search unit using the false position method achieves frequency lock in 6 iterations that correspond to 192 reference clock cycles. A prototype ADPLL using a BBPFD with a dead-zone-free retimer, an ALGC, a fractional divider, and a digital logic implementation of a frequency search algorithm was fabricated in a 0.13-μm CMOS logic process. The core occupies 0.2 mm2 and consumes 16.5 mW with a 1.2-V supply at 1.35-GHz. Measured RMS and peak-to-peak jitter with activating the ALGC are 3.7 ps and 32 ps respectively.

27 August 2019 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
JJJaehoon Jun
Jaehoon Jun
SPSoungchul Park
Soungchul Park
JKJunho Kang
Junho Kang
SKSuhwan Kim
Suhwan Kim

9 October 2009 in IEEE Transactions on Consumer Electronics
Verified
Journal Article
Closed access
JWJong-Ywan Woo
Jong-Ywan Woo
DSDong-Yong Shin
Dong-Yong Shin
DJDeog-Yoon Jeong
Deog-Yoon Jeong
SKSuhwan Kim
Suhwan Kim
We propose a high-speed rail-to-rail 10-bit column driver with a reduced die area for LCD-TV applications. This column driver combines an 8-bit resistor-string digital-to-analog converter (R-DAC), constructed using a hybrid-type decoder to reduce the RC time delay and die area, with a 2-bit interpolation DAC. In the output buffer, error amplifiers drive a column line so as to realize a highspeed rail-to-rail drive. Gamma-corrected output voltages are generated by the resistor string of R-DAC, which contains resistors of unequal values that match the inverse of the liquid crystal transmittance-voltage characteristic. A prototype 10- bit LCD column driver was designed and fabricated using a 0.3 mum CMOS technology, and has a settling time of within 2 mus and a quiescent current of 5.4 muA per channel.