Yong-Un Jeong

Dr. Yong-Un Jeong

Seoul National University
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 December 2020 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YJYong-Un Jeong
Yong-Un Jeong
HPHyunkyu Park
Hyunkyu Park
CHChangho Hyun
Changho Hyun
JCJoohyung Chae
Joohyung Chae
SJShin-Hyun Jeong
Shin-Hyun Jeong
SKSuhwan Kim
Suhwan Kim
A single-ended four-level pulse-amplitude modulation (PAM-4) transmitter (TX) for memory interfaces achieves high signal integrity by combining an impedance-matched PAM-4 driver with a three-point ZQ calibration scheme. This improves PAM-4 linearity by allowing the driver to compensate for its impedance variation caused by the change in the drain-source voltage (VDS) to suit the four output levels considering both the TX and the receiver (RX). Resistors and inductors are eliminated from the voltage-mode (VM) driver, reducing the area requirement. The two-tap asymmetric feed-forward equalization (FFE) allocates six different coefficients to each minimum pull-up and pull-down transition, compensating for nonlinear equalization strengths and asymmetric characteristics of the driver. A prototype chip fabricated in the 65-nm CMOS has an area of 0.0333 mm² and consumes 0.64 pJ/bit. It achieves a data rate of 28 Gb/s/pin with a ratio level separation mismatch (RLM) of 0.993.

23 April 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
JCJoohyung Chae
Joohyung Chae
YJYong-Un Jeong
Yong-Un Jeong
SKSuhwan Kim
Suhwan Kim
We combine 2-tap feed-forward amplitude equalization with phase equalization by 4-tap integrated pulse-width modulation. In a VSS-terminated transmitter, amplitude equalization is selected for pull-up data transmission, and phase equalization for pull-down data transmission, and the strength of equalization can be controlled depending on channel losses. This combines the strength of amplitude equalization with the energy efficiency of phase equalization. A prototype quarter-rate transmitter for memory interfaces, fabricated in a 65nm CMOS process, performed single-ended signaling at a data-rate of 16Gb/s/pin over a channel with a loss of 14.7dB. Its energy efficiency is 1.04pJ/bit/pin and the figure-of-merit is 0.070pJ/bit/pin/dB.

20 July 2023 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
YJYong-Un Jeong
Yong-Un Jeong
SCSungphil Choi
Sungphil Choi
SKSuhwan Kim
Suhwan Kim
JCJoohyung Chae
Joohyung Chae
In multi-lane interfaces using single-ended signaling such as memory interfaces, far-end crosstalk (FEXT) noise of the aggressor signal severely degrades signal integrity of the victim signal. A circuit for crosstalk cancellation (XTC) can reduce FEXT noise. However, the channel spacing makes the flight time difference between the forward and FEXT signals. As a result, the residual FEXT can remain. To further minimize the residual FEXT, this study proposes an XTC method to adjust the amplitude and timing independently. The timing is adjusted according to the passive element’s value of the differentiator, and the amplitude is varied by using the high-frequency boosting circuit. Moreover, a continuous-time linear equalizer (CTLE) and a 1-tap decision feedback equalizer (DFE) are applied to reduce inter-symbol interference. A prototype chip of 2-lane receiver was fabricated in a 55-nm CMOS process to verify this scheme. Using the proposed XTC, CTLE, and 1-tap DFE, timing margins of 0.21 UI and 0.36 UI were achieved in 6-mil and 15-mil channel spacings at 6.4 Gb/s, both at a bit error rate of 10 $^{-12}$ .

31 May 2023 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
YJYong-Un Jeong
Yong-Un Jeong
JCJoohyung Chae
Joohyung Chae
SKSuhwan Kim
Suhwan Kim
A single-ended transmitter achieves low power consumption with an integrated voltage modulation (IVM) scheme for memory interfaces. The transmitter preserves the power advantages of the ground (VSS)-terminated single-ended signaling by consuming no static power when transmitting logic-0s before the last bit of consecutive logic-0s (CLZs). All the intersymbol interference (ISI) accumulated during CLZs is compensated at once by the proposed IVM, which provides the unit interval (UI) spaced compensation voltage during the period of the last logic-0. The equalization, combining four-tap IVM and two-tap pull-up feed-forward equalization (FFE), allows the transmitter to be energy efficient without degrading the compensation effect. Per-UI basis IVM also has better immunity to noise and process, supply voltage, and temperature (PVT) variations than conventional phase equalization and pulsewidth modulation. The compensation effect and power consumption of IVM are also mathematically analyzed and compared with other conventional equalizations. A prototype chip fabricated in 65-nm CMOS has an area of 0.0168 mm $^{2}$ and achieves a data rate of 16 Gb/s/pin over a transmission channel with $-$ 12.6 dB loss, with an energy efficiency of 0.85 pJ/bit.

24 August 2021 in IEEE Access
Verified
Journal Article
Open access
SCSungphil Choi
Sungphil Choi
YJYong-Un Jeong
Yong-Un Jeong
JCJoohyung Chae
Joohyung Chae
SJShin-Hyun Jeong
Shin-Hyun Jeong
SKSuhwan Kim
Suhwan Kim
The signal integrity of dual-rank LPDDR5 interface is challenged by reflections from the stub of the inactive rank within the redistribution layer (RDL). These reflections arrive at the active rank within the unit-interval of the data-rate and distort not only the post-cursor but also the pre-cursor of the signal that the decision feedback equalizer (DFE) cannot remove. We introduce a differentiating receiver that restores data through edge information to eliminate the reflective distortions, including the pre-cursor, and a transition-detecting DFE to address remaining inter-symbol interference. A prototype receiver, fabricated in a 65 nm CMOS process, eliminates pre-cursor distortion with a reflection flight time of 50 ps and 70 ps, at 8 Gb/s and 6.4 Gb/s, resulting in a wide horizontal margin at a bit-error-rate of 10 -12 . The energy efficiency is 0.80 pJ/bit at 8 Gb/s.

4 July 2022 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
SLSangyoon Lee
Sangyoon Lee
YJYong-Un Jeong
Yong-Un Jeong
JYJaekwang Yun
Jaekwang Yun
JCJoohyung Chae
Joohyung Chae
SKSuhwan Kim
Suhwan Kim
This paper presents a single-ended transmitter for a low-power DRAM that switches equalization modes to provide improved matching to channel impedance and reduced energy consumption. The transmitter’s voltage-mode driver responds to the incoming data by selecting between phase equalization and current-mode amplitude equalization. The impedance matching with the channel is further improved by reducing the variation in on-resistance exhibited by the driver. A prototype chip that uses supply voltages of 0.5 V for the driver, and 1.05 V for rest of the blocks, was fabricated in a 65 nm CMOS process and occupied 0.0698 mm2. This prototype can compensate for a channel loss of 11.8 dB at a data-rate of 12 Gb/s while consuming 1.30 pJ/bit.