1 January 2017 in Procedia Manufacturing
1 January 2012 in WORK: A Journal of Prevention, Assessment & Rehabilitation
During the last decades of the previous century, school desks with a tilt top have disappeared. The chairs have been designed for sitting upright, with the hip, knees and ankles all at right angles. However, the erect posture cannot be maintained for more than one or two minutes, after which it will result in fatigue, discomfort or poor posture. The main aim of project is to identify the type of furniture that most effectively contribute to adequate neck and back postures of the school children, by carrying out a postural analysis of a sample of school pupils when using three different types of furniture. The postures adopted by school pupils were monitored by video during several activities, such as reading, writing and painting tasks, copying from a blackboard and listening the teacher. Additionally, the characteristics of the adopted postures were assessed by registering the head tilt, flexion of the neck, trunk and hips position. All these aspects were classified and the results were recorded for future analysis. The obtained results seem to point out that the use of a school desk with a tilted table surface resulted in a reduction in trunk and neck flexion, preserving the natural lordosis in the lumbar and cervical regions. Accordingly, it can be concluded that there are alternatives to consider in the furniture design in order to eliminate tensions and, consequently, to improve children’s wellbeing.
3 October 2018 in International Journal of Occupational and Environmental Safety
Striving to improve productivity, industries have used different management approaches, being lean manufacturing the most used over recent years. Lean manufacturing is based on value creation for the customer and elimination of waste that occurs during the production process, while improving working conditions. The incorporation of ergonomic aspects in the workstation design also contributes for the referred objectives, since it will reduce awkward postures or excessive effort during work, leading to better working conditions and increased productivity. The present study highlights, through a case study in four production areas of a metallurgical industry, the benefits of using an integrated operations management approach to improve productivity and ergonomic aspects. Several ergonomic methods, such as Rapid Upper Limb Assessment (RULA), Strain Index (SI), and Rapid Entire Body Assessment (REBA), were chosen to evaluate the ergonomic situation and lean manufacturing tools such as Value Stream Mapping (VSM) and 7 wastes were also used to analyze the systems and increase the productivity by eliminating several wastes. The results of this study show that it is possible, and desirable, to consider both aspects, ergonomic conditions and productivity, during continuous improvement’ implementations. In fact, the improvements reached through the advances in ergonomic conditions can contribute very positively for productivity increasing.