9 February 2022 in Physical Review Applied
Laser interferometers are the core measurement tool in gravitational wave observatories. An important factor that can limit the performance is the relative power instability of the laser, a problem often called relative intensity noise (RIN). But exactly how this influences the interferometer performance is not completely understood. Therefore in this paper we analyze laser RIN coupling into the phase readout in balanced and unbalanced heterodyne interferometers. We describe the coupling theoretically, then simulate and finally measure it. Our results reveal a combination of RIN contributions from the heterodyne frequency and twice the heterodyne frequency in the interferometric phase readout. We also show that when an additional, correlated reference measurement is subtracted the combined coupling factor depends on the differential phase between the two measurements and thus can be minimized. Our results have implications for noise models in future space-based gravitational wave observatories like Laser Interferometer Space Antenna, where RIN-to-phase coupling arises directly and is modulated via spacecraft jitter, testmass position and orientation.
1 December 2018 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
30 October 2025 in Classical and Quantum Gravity
Various noise sources will impact the laser interferometer space antenna (LISA) interferometric measurements, particularly laser frequency noise, which will dominate by several orders of magnitude. To achieve the required sensitivity for gravitational wave detection, noise reduction methods, such as the time-delay interferometry (TDI) algorithm, must be employed and tested using both computer and instrumental simulations. For this purpose, the electro-optical simulator LISA On table has been used to generate realistic LISA signals at the APC laboratory. This experiment also allows the testing of a LISA phasemeter (PM) prototype. In this paper, we experimentally demonstrate the coupling between the TDI algorithm and the PM anti-aliasing filters, which leads to the appearance of aliasing and non-stationary noise at high frequencies. We also propose an analytical model that allows us to estimate the impact of this coupling on our data and to constrain the design of the cascaded integrator-comb filter for a simplified LISA constellation. In addition, we explore the periodicity and impact of this non-stationarity in the case of a simplified LISA-like constellation with linearly evolving arm length.
31 March 2026 in Classical and Quantum Gravity
The Laser Interferometer Space Antenna (LISA) observatory is a future L3 mission of the European Space Agency to detect gravitational waves, set to launch in 2035. The detector constellation will conduct interferometry to extreme precision over an unprecedented armlength of 2.5 million kms. In this paper, we present the development and testing results for the Zerodur interferometer (ZIFO), an optical demonstrator built to validate critical technology for the test setup of LISA’s interferometric core. Optical pathlength stability measurements on the ZIFO demonstrate successful reduction of bench noise to maintain the 10 pm specification across the 1 mHz to 1 Hz frequency band. We also identify and characterize dominant noise sources from phasemeters and correlations of beam tilt into the pathlength that are observed during the test campaign.
4 March 2026 in Classical and Quantum Gravity
Space-based gravitational wave detectors are potentially limited by a noise source arising from the coupling between interferometric beam jitter and the interferometer’s length readout. A significant optical property responsible for this coupling is the wavefront error, defined as distortions in the phase profile of the laser beam. In this paper, we investigate this tilt to length (TTL) coupling induced by wavefront errors by developing two independent simulation tools that employ different computational methods to quantify the coupling amplitude. We analyze the characteristics of distortion-induced TTL coupling and present the relationship between the magnitude of wavefront distortions—expressed through a Zernike polynomial decomposition—and the resulting coupling amplitude. These results provide critical specifications for the design of an optical test bench intended to experimentally verify the performance of the LISA instrument on ground.
19 November 2025 in Classical and Quantum Gravity
In early 2024, European Space Agency formally adopted the Laser Interferometer Space Antenna (LISA) space mission with the aim of measuring gravitational waves emitted in the millihertz range. The constellation employs three spacecraft (SC) that exchange laser beams to form interferometric measurements over a distance of 2.5 million km. The measurements will then be telemetered down to Earth at a lower sampling frequency. Anti-aliasing filters will be used on board to limit spectral folding of out-of-band laser noise. The dominant noise in these measurements is laser frequency noise which does not cancel naturally in LISA’s unequal-arm heterodyne interferometers. Suppression of this noise requires time-shifting of the data using delay operators to build virtual beam paths that simulate equal-arm interferometers. The non-commutativity of these delay operators and on-board filters manifests as a noise (flexing-filtering) that significantly contributes to the noise budget. This non-commutativity is a consequence of the non-flatness of the filter in-band. Attenuation of this noise requires high-order and computationally expensive filters, putting additional demands on the SC. The following work studies an alternative method to reduce this flexing filtering noise via the introduction of a modified delay operator that accounts for the non-commutativity with the filter in the delay operation itself. Our approach allows us to reduce the flexing-filtering noise by over six orders of magnitude whilst reducing the dependency on the flatness of the filter. The work is supplemented by numerical simulations of the data processing chain that compare the results with those of the standard approach.