29 September 2023 in IEEE Transactions on Microwave Theory and Techniques
This article presents a wideband phase-locked loop (PLL) with a novel frequency acquisition loop for a wide locking range and wide bandwidth in 130 nm SiGe BiCMOS technology. The PLL contains two channels that work in parallel for the frequency acquisition and phase locking to form an analog phase frequency detector (PFD). The proposed frequency acquisition loop enables a fast frequency correction with a wide pull in range and accommodates frequency acquisition when a significant frequency difference is presented. The designed PLL provides the bandwidth of 55 MHz, a phase margin (PM) of 81.5 $^{\circ}$ , and offers a wide frequency acquisition of 4.1 GHz. The proposed architecture allows simultaneous carrier synchronization and data de-modulations at front-end. The PLL has a measured phase noise of $-$ 124 dBc/Hz@1 MHz and the root mean square (rms) jitter integrated from 100 Hz to 1 GHz of 62.4 fs.
19 December 2024 in IEEE Transactions on Microwave Theory and Techniques
SZSaeed Zeinolabedinzadeh
We present a novel, scalable, distributed beamforming receiver array architecture capable of self-synchronization using an analog phase-locked loop (PLL). Wireless frequency synchronization of distributed nodes is achieved at the receiver front-end and at carrier frequency level with extremely low latency, while direct data demodulation is performed at the same time. Compared to existing techniques, frequency synchronization is accomplished without using back-and-forth feedback between the radio nodes within the distributed network. In this work, we demonstrate the wireless beamforming operation through phase alignment of synchronized signals at the output of PLLs. The local oscillator (LO) signal at each receiver is automatically synchronized with the received signal, and the receiver directly down-converts and demodulates the data. Therefore, the need for phase alignment at the carrier frequency translates to the delay adjustment of the demodulated data at an intermediate frequency (IF) for beamforming. A custom-designed receiver at the millimeter-wave frequency band fabricated in GlobalFoundry’s SiGe BiCMOS technology was used for this study. We provide a comprehensive study of distributed beamforming arrays (DBAs) in the presence of interference signals. The emergence of spurious intermodulation (IM) components in the output spectrum of the PLL due to interference signal was observed. We experimentally demonstrate that the coherent combination of signals from different receiving nodes can significantly suppress the interference in distributed arrays once accurate phase alignment of carrier signals is achieved. Additionally, the effects of interference on the phase noise were experimentally studied. A 130-Mb/s data link was established between the transmitter and distributed receiver array by introducing appropriate time delays during the post-processing stages.
2 June 2021 in IEEE Transactions on Nuclear Science
This article presents novel radiation hardening design techniques to substantially reduce the single-event effects (SEEs) on high-frequency receivers subject to various radiations when operating in space. A $W$ -band (75–110 GHz) receiver front-end implemented in Global Foundry’s 90-nm silicon–germanium (SiGe) BiCMOS technology is used for studying SEE and investigating the effectiveness of the proposed techniques. Specifically, the mixer is modified to allow for different modes of operation in addition to introducing matching considerations between the mixer’s gain and switching stages. The receiver includes integrated high-frequency signal sources to provide the input radio frequency (RF) and local oscillator (LO) signals for full operation of the proposed millimeter-wave (mmW) receiver. Measurements are taken while the receiver is in normal operation (RF and LO are applied). The design techniques are carefully analyzed via extensive simulations using equivalent transient current pulses obtained from calibrated technology computer-aided design (TCAD) simulations. A two-photon absorption (TPA) pulsed laser experiment is used to induce transient currents in the silicon–germanium heterojunction bipolar transistor (SiGe HBT) circuit. Various devices within the mixer are hit from the back side through a hole in the designed printed circuit board (PCB). The propagated transients are then captured using a high-speed oscilloscope at the output of the receiver. The measurement results, supported by simulations and analysis, validate the robustness of the proposed radiation hardened receiver to SEE.
3 January 2024 in IEEE Transactions on Terahertz Science and Technology
This work presents a novel terahertz THz sideband separating receiver (SSR) implemented in silicon germanium (SiGe) 0.13 μm BiCMOS technology that covers a broad frequency range of 220-320 GHz. The proposed architecture provides simultaneous observation of spectral lines with high image rejection ratio (IRR) across the entire operating frequency range. The double down conversion architecture with a first mixer operating as a sub-harmonic mixer was configurated as a sideband separating receiver leveraging the Weaver topology to provide two differential channels, one for the upper sideband (USB) and one for the lower sideband (LSB). The presented design demonstrates an IRR exceeding 20 dB across the entire frequency range of 220-320 GHz, without the need for calibration. To the best of the author's knowledge, this is the first reported H-band simultaneous sideband separation receiver in silicon technology. The fabricated receiver measures 1.2×1 mm2 and consumes 19 mW (not including LO power consumption), showcasing its potential for application in multiple-pixel arrays for space-borne observations.
26 June 2025 in IEEE Journal of Microwaves
SZSaeed Zeinolabedinzadeh
+2
This article presents a custom-made SiGe-based transceiver at millimeter-wave frequencies capable of the generation anddetection of radio waves with helical phase distribution called orbital angular momentum (OAM). The proposed architecture isable to suppress the in-band interference at the front-end that otherwise cannot be filtered by front-end filters. The transmitter and receiver chip integrates a front-end power amplifier (PA), phase shifter, low-noise amplifier (LNA), and front-end switches to switch the amplifiers ON and OFF to generate OAM modes. A 4-element transceiver array was constructed using custom-designed chips, mounted on a PCB with a custom-designed circular antenna array. The design generates $l=0$, (+1) and (−1) OAM modes simultaneously, where the mode ($l=0$) is a plane wave mode. Since each mode carries the same information, it is shown that if an interfering signal disrupts the plane wave mode ($l$ = 0), the information can still be recovered from the OAM mode ($l$ = +1), where the interferer is suppressed due to a particular detection method of the OAM wave at the receiver. The experiments show 19 dB interference suppression near the operating frequency of the OAM mode.
10 June 2025 in IEEE Transactions on Microwave Theory and Techniques
This article presents the design, implementation, and experimental evaluation of a custom-designed chip-scale distributed transmit beamforming (DTB) array operating at millimeter-wave frequencies. Each transmitting node incorporates a phase-locked loop (PLL), a phase shifter, and a power amplifier, all fabricated using a 0.13- $\mu \text {m}$ SiGe HBT BiCMOS process. The transmitters are packaged with a custom high-gain patch antenna array to enable millimeter-wave signal transmission. Wireless coherent beamforming was experimentally demonstrated using an array of spatially distributed transmitter nodes synchronized to a common reference signal. The array achieves over 93% of the ideal coherent gain. Solid frequency synchronization was achieved using the on-chip PLLs, resulting in a stable signal with improved phase noise results after beamforming. In addition, a comprehensive analysis of phase noise in DTB arrays is presented and experimentally validated, demonstrating near-theoretical and repeatable phase noise improvements. The impact of frequency synchronization errors and receiver displacement on signal integrity is also investigated, emphasizing the critical role of precise phase and frequency synchronization.