The advantages and the tradeoffs associated with the use of inverse-mode (IM) silicon–germanium (SiGe) heterojunction bipolar transistors (HBTs) biasing circuitry in radio-frequency (RF) voltage-controlled oscillators (VCOs) have been investigated and the performance of proposed VCOs (IM VCOs) is compared with VCOs with conventional forward-mode (FM) SiGe-HBTs (FM VCOs). Where the high-frequency performance of IM VCOs is inevitably degraded due to unfavorable device optimization unlike FM VCOs, IM VCOs provide acceptable low-GHz VCO circuit performance. In terms of single-event effects (SEEs), the IM VCOs show reduced transient peaks and duration in comparison with conventional FM VCOs. In addition, the performance of the VCOs is analyzed in terms of transient error vector magnitude (TEVM) in an RF receiver (RX) using quadrature phase-shift keying (QPSK) modulation under a radiation environment. The IM VCOs in the RX circuit show better reliability under SEEs, offering 28.2% lower TEVM at a 64 Mb/s data rate, than that of the RX circuit with conventional FM VCOs. Therefore, the application of IM SiGe-HBT biasing circuits for RF VCOs can be a viable SEE-hardening technique for space-based RF systems. The VCO prototype was fabricated using IHP 130-nm SiGe bipolar complementary metal-oxide-semiconductor (BiCMOS) technology.
10 June 2025 in IEEE Transactions on Microwave Theory and Techniques
This article presents the design, implementation, and experimental evaluation of a custom-designed chip-scale distributed transmit beamforming (DTB) array operating at millimeter-wave frequencies. Each transmitting node incorporates a phase-locked loop (PLL), a phase shifter, and a power amplifier, all fabricated using a 0.13-$\mu \text {m}$ SiGe HBT BiCMOS process. The transmitters are packaged with a custom high-gain patch antenna array to enable millimeter-wave signal transmission. Wireless coherent beamforming was experimentally demonstrated using an array of spatially distributed transmitter nodes synchronized to a common reference signal. The array achieves over 93% of the ideal coherent gain. Solid frequency synchronization was achieved using the on-chip PLLs, resulting in a stable signal with improved phase noise results after beamforming. In addition, a comprehensive analysis of phase noise in DTB arrays is presented and experimentally validated, demonstrating near-theoretical and repeatable phase noise improvements. The impact of frequency synchronization errors and receiver displacement on signal integrity is also investigated, emphasizing the critical role of precise phase and frequency synchronization.
29 July 2025 in IEEE Microwave and Wireless Technology Letters
This letter presents a SiGe heterojunction bipolar transistor (SiGe HBT)-based N-path receiver with a simple noise-reduction feedback path to improve the overall noise of the receiver. Noise from local oscillator (LO) switches constitutes a significant portion of the total noise in N-path architecture at millimeter-wave (mmW) frequencies. The switch noise increases when sinusoidal LO signals are used, particularly in the absence of a perfect nonoverlapping LO signal at mmW frequencies. To reduce the switch noise, we implemented a negative feedback path, which helps reduce the noise from the switch and LO buffers. In this work, two SiGe HBT-based N-path receivers with and without feedback networks were fabricated in 130-nm SiGe BiCMOS technology, where the receiver with feedback network shows 8-dB lower noise figure (NF) compared to the architecture without feedback system at 28 GHz. The fabricated chip shows a conversion gain of −5.9 dB and P1dB of −16.42 dBm at 30GHz.