Gang Chen

Gang Chen

Auto-generated profile, based on publicly available information

Gang Chen

Department of Electronic Information and Electrical Engineering, Chengdu University, Chengdu, China

Research Focus & Metrics

Academic Career Length

27Years (2000-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 July 2007
Verified
Conference Paper
Open access
MFMingli Fu
Mingli Fu
GCG. Chen
G. Chen
LDLeonard Alexander Dissado
Leonard Alexander Dissado
JFJ. C. Fothergill
J. C. Fothergill
CZChen Zou
Chen Zou
The influence of gamma irradiation on low-density polyethylene (LDPE) has been studied through space charge measurement and dielectric spectroscopy. Commercial LDPE film with a thickness of 100μm was irradiated with γ-rays at a dose rate of approximately 10kGy/h to different doses up to 100kGy in an atmosphere of air, vacuum and nitrogen respectively. Space charge profiles vary depending on irradiation environments and radiation dose. The space charge profile of a sample after irradiation at 100kGy in air is more complicated than those irradiated in vacuum and nitrogen at same dose. More importantly, the space charge decay rate for the irradiated samples is slower than that of the virgin sample, indicating that the irradiation had changed the material by the generation of deep traps for space charge. Irradiation in air also produced changes in the dielectric spectrum in the frequency range between 10-3Hz and 106Hz where the imaginary part of the permittivity was found to be about one order of magnitude higher than that of the virgin sample (~10-4). This was attributed to oxidation as samples with the same (or lower) radiation dose in vacuum or nitrogen showed no pronounced difference to that of virgin samples.

1 July 2010
Verified
Conference Paper
Closed access
ZXZ. Xu
Z. Xu
Jun-Wei ZhaoJun-Wei Zhao
Jun-Wei Zhao
GCG. Chen
G. Chen
In this paper, an improved space charge measurement system based on the pulsed electro acoustic technique (PEA) is presented. The new system gives an essential way to examine the role of space charge in electrical aging process under AC conditions. The system setup for AC measurement is presented and detailed in this paper with comparison to the old system. There are two features with improved PEA system. A pulse generator with a 3 kHz repetition rate is utilized to reduce the measurement time. The Eclipse data acquisition system is used to achieve the high data acquisition rate. The results which were taken from both old and new PEA system show that heterocharge can be formed in the region close to the lower electrode under AC electric field. Apparently the results captured from the new system have better phase resolution than the old system. The space charge decay profile measured by the new system can reflect vividly on the charge dynamically changing. The utmost space charge information was saved as the measurement time was dramatically shortened by theσ improved system.

30 November 2023 in IEEE Transactions on Dielectrics and Electrical Insulation
Verified
Journal Article
Closed access
GCG. Chen
G. Chen
XXX. J. Xin
X. J. Xin
LLLi Luo
Li Luo
PSPucha Song
Pucha Song
HZH. C. Zuo
H. C. Zuo
In this article, a multibranching streamer discharge model considering random fluctuations of carrier density is established based on the electrohydrodynamic discharge model, and the multibranching streamer discharge under impulse voltage is carried out by finite element method. The morphologies of positive and negative streamers with multiple branches are obtained. The randomness branching characteristics of positive and negative streamers under the same voltage are explored, and the differences in branching characteristics of positive and negative streamers are analyzed. Results show that carrier density fluctuations difference significantly influences the positive and negative streamer branches, and the random fluctuations of carrier density are an essential factor for the formation of negative streamer branches. The simulation results in this article are in good reflect of the formation characteristics of positive and negative streamer branches obtained in the experiments, which can better explain the morphological differences between the positive and negative streamers.

9 May 2024 in IEEE Transactions on Dielectrics and Electrical Insulation
Verified
Journal Article
Closed access
GCG. Chen
G. Chen
XXX. J. Xin
X. J. Xin
LLLi Luo
Li Luo
PSPucha Song
Pucha Song
WKWang Kaizheng
Wang Kaizheng
HZH. C. Zuo
H. C. Zuo
A multi-branching streamer discharge model of dielectric liquid is established by considering random fluctuations of carrier density in this article. The branching and propagation characteristics of positive and negative streamers in the oil-paper interface are investigated under impulse voltage by using the finite element method. Results show that the branch and electric field strength of positive and negative streamers significantly increased after contact with the paperboard. The development characteristics between positive and negative streamers are significant differences at the oil-paper interface. The secondary branches of the dominant branch of negative streamers are more obvious than that of positive streamers, resulting in the effect of the negative secondary branches on the development of negative streamers being more serious than that of positive streamers. In addition, the negative streamer branches are more likely to develop closer to the oil-paper interface than the positive streamer branches, which is in good agreement with the experimental results, and suggests the model can well simulate the morphology and development characteristics of positive and negative streamers at the oil-paper interface.

17 October 2025 in IEEE Transactions on Dielectrics and Electrical Insulation
Verified
Journal Article
Closed access
LDLinyang Dan
Linyang Dan
XCXin Chen
Xin Chen
GCGang Chen
Gang Chen
CLChangheng Li
Changheng Li
SLSuning Liang
Suning Liang
NLNan Liu
Nan Liu
Flash point (FP) critically determines the fire safety of transformer oils, yet ester-based oils, the sustainable alternative to mineral oils, face a critical trade-off between FP enhancement and viscosity control. Consequently, molecular structure modification strategies to enhance the FP of esters emerge as a forefront research focus in insulating materials. However, current investigations remain insufficient in elucidating structure-property relationships, as the underlying mechanisms by which key molecular parameters affect FP are not systematically understood, and reliable quantitative FP prediction models for ester-based oils are underdeveloped. Thus, defining clear structure-FP correlations and developing accurate prediction methods are of critical engineering importance to guide the optimization of ester modifications. In this study, a dataset comprising 906 FP data points for ester molecules is compiled through the systematic extraction of data from published literature and chemical databases. Based on this dataset, the predictive performance of four Graph Neural Network (GNN) models is comparatively evaluated, among which AttentiveFP performs best, achieving a mean coefficient of determination (R²) of 0.97 and a mean root-mean-square error (RMSE) of 11.59°C. To further elucidate molecular interaction mechanisms, the Gradient-weighted Class Activation Mapping (Grad-CAM) technique is employed to visualize atom-level contributions. By modifying the molecular structures and analyzing FP changes, we find that FP increases with carbon chain elongation and an increase in the number of ester groups. Ester group positions show a negligible correlation with FP, except when ester groups are located at side-chain terminals, where FP decreases. While the position of C=C double bonds has minimal effect, increasing their number slightly reduces FP.

3 November 2000 in IEE Proceedings - Science, Measurement and Technology
Verified
Journal Article
Closed access
MFM. Fu
M. Fu
GCG. Chen
G. Chen
ADA.E. Davies
A.E. Davies
SSS.J. Sutton
S.J. Sutton
DPD. Patel
D. Patel
The authors describe the application of fluorimetry to determine low levels of cable oil contamination in various soil types. The study has utilised a simple extraction technique using two different solvents to investigate their efficiency, speed and reproducibility. The sensitivity of the fluorimeter has also been assessed and the results discussed and compared with those obtained by Fourier transform infrared (FTIR) spectroscopy. The results indicate that extraction efficiency over 80% is obtainable when hexane is used to extract the oil from the soil. The technique has a sensitivity of approximately 10 ppm (w/w) and has an acceptable accuracy of measurement of over 80%.