Daniel Settipani

Daniel Settipani

Auto-generated profile, based on publicly available information

Daniel Settipani

Electrochemical Energy Conversion Group Department of Chemistry and Materials Science Aalto University Kemistintie 1 02015 Espoo Finland

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2019 in Journal of Colloid and Interface Science
Verified
Journal Article
Closed access
FDFatemeh Davodi
Fatemeh Davodi
EMElisabeth Mühlhausen
Elisabeth Mühlhausen
DSDaniel Settipani
Daniel Settipani
EREeva-Leena Rautama
Eeva-Leena Rautama
AHAri-Pekka Honkanen
Ari-Pekka Honkanen
TKTanja Kallio
Tanja Kallio

8 January 2020 in Catalysts
Verified
Journal Article
Open access
PDF file
DMDJ Donn Matienzo
DJ Donn Matienzo
DSDaniel Settipani
Daniel Settipani
EIEmanuele Instuli
Emanuele Instuli
TKTanja Kallio
Tanja Kallio
Atomic layer deposition (ALD) is a special type of chemical vapor deposition (CVD) technique that can grow uniformed thin films on a substrate through alternate self-limiting surface reactions. Recently, the application of these thin film materials to catalytic systems has begun to attract much attention, and the capacity to deposit these catalytic films in a highly controlled manner continues to gain importance. In this study, IrO2 and NiO thin films (approximately 25 to 60 nm) were deposited on industrial Ni expanded mesh as an anode for alkaline water electrolysis. Different ALD operating parameters such as the total number of deposition cycles, sublimation and deposition temperatures, and precursors pulse and purge lengths were varied to determine their effects on the structure and the electrochemical performance of the thin film materials. Results from the electrochemical tests (6 M KOH, 80 °C, up to 10 kA/m2) showed the catalytic activity of the samples. Oxygen overpotential values (ηO2) were 20 to 60 mV lower than the bare Ni expanded mesh. In summary, the study has demonstrated the feasibility of using the ALD technique to deposit uniformed and electroactive thin films on industrial metallic substrates as anodes for alkaline water electrolysis.

3 June 2019 in The Journal of Physical Chemistry C
Verified
Journal Article
Open access
HNHeta-Elisa Nieminen
Heta-Elisa Nieminen
VMVille Miikkulainen
Ville Miikkulainen
DSDaniel Settipani
Daniel Settipani
LSLaura Simonelli
Laura Simonelli
PHPhilipp Hönicke
Philipp Hönicke
Mikko RitalaMikko Ritala
Mikko Ritala
LiMn2O4 is a promising candidate for a cathode material in lithium ion batteries (LIBs) due to its ability to intercalate lithium ions reversibly through its three-dimensional manganese oxide network. One of the promising techniques for depositing LiMn2O4 thin film cathodes is atomic layer deposition (ALD). Due to its unparalleled film thickness control and film conformality, ALD helps to fulfill the industry demands for smaller devices, nanostructured electrodes and all-solid-state batteries. In this work the intercalation mechanism of Li+ ions into an ALD grown β-MnO2 thin film was studied. Samples were prepared by pulsing LiOtBu and H2O for different cycle numbers onto about 100 nm thick MnO2 films at 225 ºC and characterized with X-ray absorption spectroscopy (XAS), X-ray diffraction (XRD), X-ray reflectivity (XRR), time-of-flight elastic recoil detection analysis (TOF-ERDA) and residual stress measurements. It is proposed that for < 100 cycles of LiOtBu/H2O the Li+ ions penetrate only to the surface region of the β-MnO2 film and the samples form a mixture of β-MnO2 and a lithium deficient non-stoichiometric spinel phase LixMn2O4 (0 < x < 0.5). When the lithium concentration exceeds x ≈ 0.5 in LixMn2O4 (corresponding to 100 cycles of LiOtBu/H2O), the crystalline phase of manganese oxide changes from the tetragonal pyrolusite to the cubic spinel, which enables Li+ ions to migrate throughout the whole film. Annealing in N2 at 600 ºC after the lithium incorporation seemed to convert the films completely to the pure cubic spinel LiMn2O4.

1 October 2018 in POLYMER CRYSTALLIZATION
Verified
Journal Article
Open access
PDF file
QBQuentin Beuguel
Quentin Beuguel
SBSeverine Boyer
Severine Boyer
DSDaniel Settipani
Daniel Settipani
GMGabriel Monge
Gabriel Monge
JHJean‐Marc Haudin
Jean‐Marc Haudin
EPEdith Peuvrel-Disdier
Edith Peuvrel-Disdier
Interest in graphite fillers has grown since the separation of graphene from graphite by micromechanical cleavage. The object of the article is to understand the influence of graphene nanoplatelets (GNPs) with different sizes on the crystallization behavior of a polyolefin matrix such as polypropylene (PP), after elaboration by melt mixing and compression molding. Composites with volume fractions of graphene nanoplatelets ranging from 0.3 to 2 vol% were prepared. The particle dispersion states in the composites were characterized at different scales using Scanning and Transmission Electron Microscopies (SEM and TEM). Polypropylene crystallization and orientation were investigated using optical microscopy, Differential Scanning Calorimetry (DSC) and X‐ray diffraction. This article discusses the strong acceleration of crystallization kinetics because of the presence of GNPs. The micrometric flake‐shaped GNPs act as nucleating agent and induce an epitaxial growth of alpha (α) crystalline phase of PP. The nucleating effect is related to the surface of the particles available for heterogeneous nucleation. Radial spherulitic growths are observed from the smallest micrometric particles. The coarsest GNPs, easily oriented by flow, favor PP transcrystallinity, in such a way that (010) plane of PP is parallel to (001) plane of graphene nanoplatelets.

3 June 2020 in ChemElectroChem
Verified
Journal Article
Closed access
PDF file
FFFedor Fedorov
Fedor Fedorov
DSDaniel Settipani
Daniel Settipani
MBMarthe Emelie Melandsø Buan
Marthe Emelie Melandsø Buan
JSJani Sainio
Jani Sainio
FAFarhan S. M. Ali
Farhan S. M. Ali
Albert G. NasibulinAlbert G. Nasibulin
Albert G. Nasibulin