Nanogenerator energy harvesting technologies that transform thermal energies into electricity may help address the growing need for green power. Therefore, this research aims to increase power generation by combining waste heat with pyroelectric nanogenerators as a sustainable energy source. Under optimal conditions, an external multi-pulse electric field can be utilized to generate power using thermoelectric cycle power generation. The greatest power may be gathered by applying various pulses of the external electric field at temperature changes on the surface of the pyroelectric materials. To generate pyroelectric power, a C9 BZT sample was used, and the lowest temperature difference for accomplishing this was 20 °C, with all measurements made on a sample with a lower limit of 120 °C. The maximum generation density was 0.104 mJ/cm2°CkV for a pulse width of 10 ms and 20 pulses of a low voltage (250 V/mm) input electric field. A multi-pulse electric field with low input voltage increases the power generation performance ratio (η) with the pulse count. At the largest number of pulses, the greatest η value for 250 V/mm was 7.834. Finally, it was determined that the developed pyroelectric power generation system may be more effective if a low-voltage, multi-pulse electric field is used.
A facile technique has been introduced for incorporating TiO2 nanotubes (TNTs) in amorphous polysiloxane-based nanocomposite films and for linear and dense assembling of these TNTs (LATNTs) under application of nanosecond pulse electric field. The use of a nanosecond electrical pulse enables the application of high electric power without causing dielectric breakdown, which occurs when DC/AC electric field is used, and the formation of LATNTs which anchor the resulting composite film planes. The properties of the nanocomposites were investigated using X-ray micro CT scanning, digital micrographs, UV–vis spectroscopy and electrical resistivity measurements. More than 5.5-fold UV–vis transmittance improvement was obtained by the polymer composite containing LATNTs (TNT 5.0wt%). Such a composite exhibited a decreased electric resistivity of 3.08×107Ωm compared to the case for randomly distributed TNTs (3.25×108Ωm)
1 January 2011 in Journal of the Japan Institute of Metals and Materials
Chromium nitride thin films were deposited by RF reactive unbalanced magnetron sputtering on (100) Si single-crystal or glassy carbon substrates. The characteristics of the thin films were measured by Rutherford backscattering spectroscopy, X-ray diffractometry, and scanning electron microscopy. From the results of the above measurements, it was found that our samples were stoichiometric chromium nitride thin films. The chemical bonding state was estimated using the results of the Fourier-transform infrared spectroscopy. A peak attributed to the Cr–N bond was observed at around 380 cm-1, and it could be obtained with any beam splitter and atmosphere. Furthermore, the influence of residual stress was also investigated. Residual stresses of CrN thin films, which were calculated from their strains, were quite low.