8 November 2016 in IOP Conference Series: Materials Science and Engineering
The paper examines the process of surface hardening of steel 45 with the help of high energy heating by high frequency currents with simultaneous shower water cooling. We theoretically justified and experimentally proved a possibility of liquid phase forming in the course of heating not on the surface, but in the depth of the surface layer.
1 September 2016 in Key Engineering Materials
It is impossible to improve the most critical performance properties of machine parts without methods of modifying the surface layer using such concentrated energy as laser, plasma, an electron beam or high-frequency currents. For the rational use of these methods, which are characterized by high heating rates, i.e. about 104 ... 105oC/sec a reliable mechanism for determining the processing modes that ensure the required level of quality characteristics of the hardened surface layer of machine parts, is essential. In this paper, the interrelation between the parameter values of thermal cycles, implemented in the surface layer of steel U8, and the modes of electron beam heating in the atmosphere has been determined.
1 October 2014 in Applied Mechanics and Materials
One of the prevalent ways of machining is milling, however to obtain the high fiberglass composite surface quality is difficult because of its layered structure, high strength and low thermal conductivity characteristics. This leads to the need for milling technology which provides high-quality surface. Our experiments for milling of the fiberglass composite show that the surface roughness, as one of the quality criteria, to a large depends on cutting conditions, tool material and wear of the cutting edge determined by the bevel rear tool wear. To ensure of the surface quality of the composite material during milling recommended that the bevel rear tool wear does not exceed 0.35 mm, cutting conditions were the following limits: feed speed, 0.15 – 0.17 mm/cog, depth of the cut, 0.3 – 0.6 mm, cutting speed, 45 – 48 m/s and the cutting part of the tool is made of high strength tool materials such as hard metal VK3M.
1 August 2013 in Applied Mechanics and Materials
Issues related to processing modern high-strength composites have been discussed. The reasons for degradation of performance of metallic binder diamond tools in traditional processing are highlighted. Design solutions for practical modernization of general-purpose metal-grinding equipment are offered. Advantages of combined diamond tool processing are defined to provide effective applica
1 February 2011 in Russian Engineering Research
1 June 2017 in Key Engineering Materials
The paper presents results of the investigation into efficiency of high-tensile composite materials grinding with metal bonded diamond abrasive tools, as well as it demonstrates the necessity to stabilize diamond disks cutting properties in order to reduce cutting power, since it is one of important economic indicators of processing. The comparative analysis of preliminary studies of various diamond processing methods reveals that the minimal cutting power is observed when using the combined method of electric powered diamond processing which includes electrochemical grinding and simultaneous continuous electrochemical dressing of the grinding disk surface. Further research into the suggested method reveals relevant mathematical dependences of metal-bonded diamond disks cutting power and electric modes. The analysis of the results shows that combining of hard-alloy surface electrochemical dissolution and electrochemical dressing of the disk surface facilitates mechanical cutting with high effectiveness and little effort. This leads to substantial reduction of cutting power as compared with other methods. The reasonable electric modes are discovered which provide the minimal cutting power without reducing efficiency of the process and quality of finished product.