Alba Zappone

Alba Zappone

Auto-generated profile, based on publicly available information

Alba Zappone

Swiss Seismological Service ETH Zurich Zurich Switzerland

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 February 2021 in Solid Earth
Verified
Journal Article
Open access
PDF file
AZAlba Zappone
Alba Zappone
ARAntonio Pio Rinaldi
Antonio Pio Rinaldi
MGMelchior Grab
Melchior Grab
QWQuinn C. Wenning
Quinn C. Wenning
CRClément Roques
Clément Roques
SWStefan Wiemer
Stefan Wiemer
The success of geological carbon storage depends on the assurance of permanent containment for injected carbon dioxide (CO2) in the storage formation at depth. One of the critical elements of the safekeeping of CO2 is the sealing capacity of the caprock overlying the storage formation despite faults and/or fractures, which may occur in it. In this work, we present an ongoing injection experiment performed in a fault hosted in clay at the Mont Terri underground rock laboratory (NW Switzerland). The experiment aims to improve our understanding of the main physical and chemical mechanisms controlling (i) the migration of CO2 through a fault damage zone, (ii) the interaction of the CO2 with the neighboring intact rock, and (iii) the impact of the injection on the transmissivity in the fault. To this end, we inject CO2-saturated saline water in the top of a 3 m thick fault in the Opalinus Clay, a clay formation that is a good analog of common caprock for CO2 storage at depth. The mobility of the CO2 within the fault is studied at the decameter scale by using a comprehensive monitoring system. Our experiment aims to close the knowledge gap between laboratory and reservoir scales. Therefore, an important aspect of the experiment is the decameter scale and the prolonged duration of observations over many months. We collect observations and data from a wide range of monitoring systems, such as a seismic network, pressure temperature and electrical conductivity sensors, fiber optics, extensometers, and an in situ mass spectrometer for dissolved gas monitoring. The observations are complemented by laboratory data on collected fluids and rock samples. Here we show the details of the experimental concept and installed instrumentation, as well as the first results of the preliminary characterization. An analysis of borehole logging allows for identifying potential hydraulic transmissive structures within the fault zone. A preliminary analysis of the injection tests helped estimate the transmissivity of such structures within the fault zone and the pressure required to mechanically open such features. The preliminary tests did not record any induced microseismic events. Active seismic tomography enabled sharp imaging the fault zone.

21 June 2024 in Tectonics
Verified
Journal Article
Open access
ACAlberto Ceccato
Alberto Ceccato
WBW. M. Behr
W. M. Behr
AZA. S. Zappone
A. S. Zappone
LTL. Tavazzani
L. Tavazzani
Andrea GiulianiAndrea Giuliani
Andrea Giuliani
The rheology of crystalline units controls the large‐scale deformation geometry and dynamics of collisional orogens. Defining a time‐constrained rheological evolution of such units may help unravel the details of collisional dynamics. Here, we integrate field analysis, pseudosection calculations and in situ garnet U–Pb and mica Rb–Sr geochronology to define the structural and rheological evolution of the Rotondo granite (Gotthard nappe, Central Alps). We identify a sequence of four (D1–D4) deformation stages. Pre‐collisional D1 brittle faults developed before Alpine peak metamorphism, which occurred at 34–20 Ma (U–Pb garnet ages) at 590 ± 25°C and 0.9 ± 0.1 GPa. The reactivation of D1 structures controlled the rheological evolution, from D2 reverse mylonitic shearing at amphibolite facies (520 ± 40°C and 0.8 ± 0.1 GPa) at 18–20 Ma (white mica Rb–Sr ages), to strike‐slip, brittle‐ductile shearing at greenschist‐facies D3 (395 ± 25°C and 0.4 ± 0.1 GPa) at 14–15 Ma (white mica and biotite Rb–Sr ages), and then to D4 strike‐slip faulting at shallow conditions. Although highly misoriented for the Alpine collisional stress orientation, D1 brittle structures controlled the localization of D2 ductile mylonites accommodating fast (∼3 mm/yr) exhumation rates due to their weak shear strength (<10 MPa). This structural and rheological evolution is common across External Crystalline Massifs (e.g., Aar, Mont Blanc), suggesting that the European upper crust was extremely weak during Alpine collision, its strength controlled by weak ductile shear zones localized on pre‐collisional deformation structures, that in turn controlled localized exhumation at the scale of the orogen.

15 November 2024 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
AOAnne Obermann
Anne Obermann
MRMartina Rosskopf
Martina Rosskopf
VDVirginie Durand
Virginie Durand
KPKatrin Plenkers
Katrin Plenkers
KBKai Bröker
Kai Bröker
DGDomenico Giardini
Domenico Giardini
We performed a series of hydraulic stimulations at 1.1 km depth in the Bedretto underground laboratory, Switzerland, as part of an overall research strategy attempting to understand induced seismicity on different scales. Using an ultra‐high frequency seismic network we detect seismic events as small as Mw < −4, revealing intricate details of a complex fracture network extending over 100 m from the injection sites. Here, we outline the experimental approach and present seismic catalogs as well as a comparative analysis of event number per injection, magnitudes, b‐values, seismogenic index and reactivation pressures. In our first‐order seismicity analysis, we could make the following observations: The rock volume impacted by the stimulations in different intervals differs significantly with a lateral extent from a few meters to more than 150 m. In most intervals multiple fractures were reactivated. The seismicity typically propagates upwards toward shallower depth on parallel oriented planes that are consistent with the stress field and seem to a large extent associated with preexisting open fractures. This experiment confirms the diversity in seismic behavior independent from the injection protocol. The overall seismicity patterns demonstrate that multi‐stage stimulations using zonal isolation allow developing an extended fracture network in a 3D rock volume, which is necessary for enhanced geothermal systems. Our stimulations covering two orders of magnitude in terms of injected volume will give insights into upscaling of induced seismicity from underground laboratory scale to field scale.

19 April 2021 in Swiss Journal of Geosciences
Verified
Journal Article
Open access
PDF file
AZAlba Zappone
Alba Zappone
EKEduard Kissling
Eduard Kissling
The Swiss Atlas of Physical Properties of Rocks (SAPHYR) project aims at centralize, uniform, and digitize dispersed and often hardly accessible laboratory data on physical properties of rocks from Switzerland and surrounding regions. The goal of SAPHYR is to make the quality-controlled and homogenized data digitally accessible to an open public, including industrial, engineering, land and resource planning companies as well as governmental and academic institutions, or simply common people interested in rock physics. The physical properties, derived from pre-existing literature or newly measured, are density, porosity and permeability as well as seismic, magnetic, thermal and electrical properties. The data were collected on samples either from outcrops or from tunnels and boreholes. At present, data from literature have been collected extensively for density, porosity, seismic and thermal properties. In the past years, effort has been placed especially on collecting samples and measuring the physical properties of rock types that were poorly documented in literature. A workflow for quality control on reliability and completeness of the data was established. We made the attempt to quantify the variability and the uncertainty of the data. The database has been recently transferred to the Federal Office of Topography swisstopo with the aim to develop the necessary tools to query the database and open it to the public. Laboratory measurements are continuously collected, therefore the database is ongoing and in continuous development. The spatial distribution of the physical properties can be visualized as maps using simple GIS tools. Here the distribution of bulk density and velocity at room conditions are presented as examples of data representation; the methodology to produce these maps is described in detail. Moreover we also present an exemplification of the use of specific datasets, for which pressure and temperatures derivatives are available, to develop crustal models.

1 December 2016 in Tectonophysics
Verified
Journal Article
Closed access
QWQuinn C. Wenning
Quinn C. Wenning
Bjarne AlmqvistBjarne Almqvist
Bjarne Almqvist
PHPeter Hedin
Peter Hedin
AZAlba Zappone
Alba Zappone

13 May 2017 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Closed access
PDF file
QWQuinn C. Wenning
Quinn C. Wenning
TBTheo Berthet
Theo Berthet
MAMaria Ask
Maria Ask
AZAlba Zappone
Alba Zappone
JRJan‐Erik Rosberg
Jan‐Erik Rosberg
Bjarne AlmqvistBjarne Almqvist
Bjarne Almqvist