Natural fiber is a resource that is found abundantly and cost effective. It is decomposed easily and biodegradable. Natural fibers have a vital place in the industry and have the capability of replacing carbon fibers and conventional glass because of their biodegradability and eco-friendly characteristics. They have significant chemical, mechanical, and physical properties, which vary according to cellulose content in the fiber. Usually, with the increase in the cellulose content, the tensile strength of the fiber increases and with the increase in the non-cellulose content, the tensile strength of the fiber decreases. However, these chemical constituents are not the only factors that determine the tensile strength of the fiber. Certain other factors such as fiber age, maturity, location, and processing methods along with the source of the fiber also influence the tensile strength of the fiber. These properties of the natural fibers make it a vital component in engineering applications. Natural fibers meet the needs of humans and the manufacturing industry with their positive environmental effect and economic outlook. This review provides basic information and a segregated study on the mechanical properties of natural fibers, thus creating opportunities for future research and studies related to natural fiber–reinforced composites.
In this investigation, the mechanical behaviour and microstructural examination of friction stir processed (FSP) Tungsten Inert Gas (TIG) welded aluminium dissimilar alloys has been studied. The research is proposed to enhance the mechanical characteristics of the aluminium alloy 5052-H32 and aluminium alloy 5083-H111 TIG FSP welded joints. Initially, the TIG welding was done to join aluminium alloy 5052-H32 and aluminium alloy 5083-H111 by employing a ER5356 filler rod. TIG welding is performed by using the following parameters: tungsten electrode diameter (2.4 mm), Current (170 A) and a shielding gas flow rate (argon) (11 l·min-1). Secondarily, the FSP is carried out on TIG welded aluminium alloy 5052-H32 and aluminium alloy 5083-H111 by using different tool rotation speeds (850 to 1050 rpm), tool traverse speeds (24 to 32 mm·min-1) and different number of passes (1 to 3) with a cylindrical pin less tool. The FSP parameters are designed by the Taguchi L9 array to compute the optimized parameters. The tensile strength, microhardness and % of elongation are determined for a total of nine specimens. Finally, the grey relational analysis (GRA) is employed to find out the best FSP parameter out of the set of FSP parameters. The optimal parameters of FSP are a tool rotation speed of 950 rpm, tool traverse speed of 28 mm/min and number of passes of 3. The number of passes are the most influencing factor when compared to other two FSP parameters.
This study explores the novel design of geometric rubbing profiles on rotary friction welding for enhanced mechanical clamping in joining dissimilar alloys such as copper and stainless steel 316L. The clamping behavior of rubbing profiles could hold the yielding of the weld joint to a maximum level. An innovative approach to effective mixing of the weldment zone could be achieved through the definition of rubbing profiles. The effective dispersion of dissimilar metallic phases could be governed by the geometrical profile in achieving the intermetallic SS-Cu phase. Variations were made in welding parameters like tool rotational speed, upset pressure, upset time, friction pressure, and friction time to find the appropriate process for the four different rubbing profiles, namely helical fluke, plus, cylindrical, and flat to achieve a reduction in micro and macro-structural defects with strong weld nugget. Results show that helical fluke rubbing profiles were seen to have explicit values like ultimate tensile strength of 217 MPa (upset pressure), elongation of 9.8 % (upset pressure), and average hardness of 125 HV (friction pressure) at the weld nugget. Microstructural characteristics prove that the formation of IMCs through grain size reduction such as cementite increases the Vickers hardness of the weldment.