Toshinori Kawabata

Toshinori Kawabata

Auto-generated profile, based on publicly available information

Toshinori Kawabata

Graduate School of Agricultural Science, Kobe University, Kobe, Japan

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2006 in Journal of Geotechnical and Geoenvironmental Engineering
Verified
Journal Article
Closed access
TKToshinori Kawabata
Toshinori Kawabata
HLHoe I. Ling
Hoe I. Ling
YMYoshiyuki Mohri
Yoshiyuki Mohri
DSDaisuke Shoda
Daisuke Shoda
The existing design guidelines for buried flexible pipes are limited to depth up to 10 m . The increasing use of difficult terrains for infrastructure, landfills, and residential and industrial developments has prompted installation of drainage pipelines under 20–30 m high fills. This paper presents the behavior of an instrumented flexible pipe buried under a 47.1 m deep fill. For filling above 20 m , the measured vertical stress above the pipe exhibited a concave distribution, corresponding to 90 and 110% of the average vertical pressure at the center and edges of the pipe, respectively. The measured results suggest that a triangular lateral pressure distribution can lead to overly conservative and uneconomical results for high fills while Spangler’s analysis is unconservative. Based on the measured results, a revised vertical and lateral earth pressure diagram was proposed for the design of flexible pipe under high fills >20 m . This paper proposes closed-form analyses for estimating the moments and dis...

2 January 2019 in Marine Georesources & Geotechnology
Verified
Journal Article
Closed access
NTNaoki TAKEGAWA
Naoki TAKEGAWA
YSYutaka Sawada
Yutaka Sawada
TKToshinori Kawabata
Toshinori Kawabata
Following the Great East Japan Earthquake, a massive tsunami caused serious damage to coastal dikes. Local scour at the ground behind these dikes reportedly causes dike failures. It is important to reveal the scour process to establish methods for effective scour countermeasures. Herein, we focus on geogrids. To verify this proposal and examine its design, flume-model experiments were performed for non-liquefied and liquefied grounds behind coastal dikes. The results showed that the scour amount and area were reduced drastically when geogrids were present. Geogrids on the sand-bed surface changed the direction of overflow water. Thus, a scour hole developed away from a coastal dike model. Furthermore, geogrids exerted a scour-reduction effect even during liquefaction.

19 June 2015 in Transportation Infrastructure Geotechnology
Verified
Journal Article
Open access
PDF file
KOKohei Ono
Kohei Ono
YSYusuke Sonoda
Yusuke Sonoda
YSYutaka Sawada
Yutaka Sawada
HLHoe I. Ling
Hoe I. Ling
TKToshinori Kawabata
Toshinori Kawabata
In Japan, a trenchless rehabilitation method has often been used for replacing aging irrigation pipes because of the economical reason. With the method, damaged host pipes are repaired with new pipes. Namely, the rehabilitated pipeline system comprises two pipes: a damaged host pipe and a liner. The mechanical behavior of liners is influenced by host pipes. In the present study, in order to reveal the mechanical behaviors, centrifuge model tests were carried out under various conditions including the damage levels of the host pipe, the positions of surcharge load, the ring stiffness of the liner, and the stiffness of the backfill. Test results indicate that the deflection of the liner increases with the damage level of the host pipe, and the influence of the host pipe on the liner is negligible when the host pipe reaches the ultimate damaged state. In addition, the strain concentration occurs at the crown of the inner due to the contact between the edge of the damaged host pipe and the liner. The strain concentration is reduced by 20 % with the increase of the ring stiffness of the liner. It is also revealed that the strain concentration appears even if the stiffness of backfills increases.

27 June 2024 in Transportation Infrastructure Geotechnology
Verified
Journal Article
Open access
PDF file
TNTaishi Nagatani
Taishi Nagatani
YSYutaka Sawada
Yutaka Sawada
RIRuka Ikebata
Ruka Ikebata
SIShuji Ito
Shuji Ito
YSYusuke Sonoda
Yusuke Sonoda
TKToshinori Kawabata
Toshinori Kawabata
In this study, we proposed a new method which mitigates pipe uplifting by utilizing geocells and geotextiles. The method resulted in labor saving in construction. To verify the effectiveness of the proposed method, we reproduced pipe uplift by conducting push-up tests using a 150-mm-diameter pipe. The test results showed that the proposed method increased the peak resistance and the resistance at large displacement by 1.47 and 3.35 times, respectively, compared to the unreinforced method. The proposed method also increased the peak resistance by 1.13 times compared to the conventional method widely used in Japan. It demonstrated consistently high resistance even after the peak. This indicated that the proposed method is very effective as a countermeasure against pipe uplift. Furthermore, increasing the overall width of the geocell improved the resistance. In this study, two different approaches were used to evaluate the uplift resistance of the pipe. The approaches showed that, with geocell reinforcement, most of the dead weight at the pipe sides and above them contributed to the peak resistance. It was also found that the peak resistance of the proposed method can be predicted to some extent by modifying the previously proposed equation.

28 July 2006
Verified
Conference Paper
Closed access
TKToshinori Kawabata
Toshinori Kawabata
YMYoshiyuki Mohri
Yoshiyuki Mohri
HTHiroyuki Tamura
Hiroyuki Tamura
DSDaisuke Shoda
Daisuke Shoda
TOTetsuya Oda
Tetsuya Oda
Field buried pipe tests were conducted using steel pipes with 3500mm-diameter and 26mm-thickness as a part of Irrigation Pipeline Project. In current design for irrigation pipeline in Japan, there are no design criteria for pipeline with diameter larger than 3000 mm. In the field tests, two cases of backfilling methods were employed. In Case 1, soil-cement was used as backfill material to a height of half the diameter measured from the bottom of the pipe. In Case 2, soil-cement was used as backfill to a height of quarter diameter measured from the bottom of the pipe. The mixed rock, which was recycled crushed concrete and crushed gravel, was backfilled above soil-cement to the top of the pipe. The pipe was buried under a depth of approximately 3.0 m in both cases. Displacement transducers were installed in the pipes and strain gauges were attached to the inner of the pipe. Earth pressure transducers and pore water pressure transducers were installed in the backfill materials around the pipes. The deformations in each of the backfilling stage were measured. It is found that the behavior of the buried pipe was strongly influenced by backfilling methods and external force.

17 July 2008
Verified
Conference Paper
Closed access
TKToshinori Kawabata
Toshinori Kawabata
YMYoshiyuki Mohri
Yoshiyuki Mohri
TOTetsuya Oda
Tetsuya Oda
DSDaisuke Shoda
Daisuke Shoda
MAMitsuru Ariyoshi
Mitsuru Ariyoshi
HNHirofumi Nakashima
Hirofumi Nakashima
This paper presents an overview of field tests for buried pipe, which were conducted using steel pipes with 3500 mm diameter and 26 mm thickness. In this full-scale test, five kinds of construction site were employed. The depth of soil cover was approximately 3.0 m in every case. Sheet pile method was employed in Case-5, and open-cut method was conducted in the other cases. Displacement transducers were installed in the pipe and strain gauges were circumferentially attached to the inner of the pipe. The deformation of pipe was observed for over a year by those measures. Therefore, it is found that the behavior of the buried pipe was strongly influenced by backfilling methods. In addition, FEM analyses were conducted to confirm the behavior of soil-pipe interaction. Thus, it is found that the inhomogeneous strength of backfill materials brings local deformation of the pipe.