1 February 2016 in Microelectronics Reliability
29 December 2016 in IEEE Transactions on Nuclear Science
This paper proposes the Active Precharge Hammering on a Row (APHR) test to evaluate displacement damage (DD) in 3x-nm DRAM components. Irradiated SDRAM devices could have multiple current leakage paths, partly owing to DD effects. The degree of leakage from cells with DD can be differentiated from undamaged cells by the difference in the number of hammered accesses to the two types of cells. Proton-based SER tests were performed with DDR3 SDRAM components made using 3x-nm technologies. The experimental results showed that bit errors caused by the APHR test (APHR errors) were more than five times higher in the irradiated sample compared to the non-irradiated sample, and APHR errors were not detectable within 64-ms retention time using the traditional retention test method. In the worst case, the number of hammerings required to cause an APHR error in the irradiated sample reduced by 36 times compared to that in the non-irradiated sample even after the irradiated sample was annealed at 150° C so as to have no retention errors within the maximum retention time of 64-ms.
1 January 2018 in Microelectronics Reliability
2 March 2015 in IEEE Transactions on Nuclear Science
This work shares the observations of stuck bits by proton beam in DDR3 components in 3x-nm technologies. The DDR3 SDRAMs from four major DRAM manufacturers were tested with a 45-MeV proton beam at an operating frequency of 800 MHz. The beam exposure resulted in single bit upset (SBU) and multiple bit upsets (MBUs), as well as single and multiple stuck bits in a word due to micro-dose and displacement damage effects. The number of stuck bits reduced as the refresh interval duration was decreased. Moreover, for the tested samples, the stuck bits were recovered completely and could be run in the normal operation mode after annealing at 150 ° C. The occurrence of multiple stuck bits in a word was likely due to damages to the control logic and those stuck bits were recovered as well after annealing at 150 ° C.
1 February 2017 in Microelectronics Reliability
23 January 2026 in IEEE Transactions on Nuclear Science
Multi-bit flip-flops (MBFFs) are widely adopted in low-power digital designs due to their ability to reduce area and clock switching power by sharing clock buffers across multiple individual flip-flops. However, this clock resource sharing introduces new bit-upsets vulnerabilities in the form of single-event transients (SETs) within the shared clock buffer, distinct from standard storage-node single-event upset (SEU). This work presents neutron-induced soft error characterization results for MBFFs implemented with both standard and radiation-hardened dual interlocked storage cell (DICE) latches in a 0.9V, 28nm CMOS technology. Neutron irradiation experiment was conducted at the ChipIR facility in the Rutherford Appleton Laboratory, UK. A total of 84 test chips containing over 800,000 flip-flops were tested under multiple voltage conditions and data patterns. Upset mechanisms were classified into storage-node upsets, local clock buffer SETs, and global scan clock SETs. The results confirm that MBFFs, despite the use of DICE for hardened storage, exhibit significantly increased susceptibility to SETs in shared clock buffers. This study highlights an important trade-off between power efficiency and radiation resilience in multi-bit flip-flop designs, calling attention to the need for targeted mitigation strategies to ensure robust system operation in radiation prone environments.