24 January 2022 in Advanced Materials
The design, fabrication, and characterization of wafer‐scale, zero‐bias power detectors based on 2D MoS2 field‐effect transistors (FETs) are demonstrated. The MoS2 FETs are fabricated using a wafer‐scale process on 8 μm‐thick polyimide film, which, in principle, serves as a flexible substrate. The performances of two chemical vapor deposition MoS2 sheets, grown with different processes and showing different thicknesses, are analyzed and compared from the single device fabrication and characterization steps to the circuit level. The power‐detector prototypes exploit the nonlinearity of the transistors above the cut‐off frequency of the devices. The proposed detectors are designed employing a transistor model based on measurement results. The fabricated circuits operate in the Ku‐band between 12 and 18 GHz, with a demonstrated voltage responsivity of 45 V W−1 at 18 GHz in the case of monolayer MoS2 and 104 V W−1 at 16 GHz in the case of multilayer MoS2, both achieved without applied DC bias. They are the best‐performing power detectors fabricated on flexible substrate reported to date. The measured dynamic range exceeds 30 dB, outperforming other semiconductor technologies like silicon complementary metal–oxide–semiconductor circuits and GaAs Schottky diodes.
9 October 2001 in Applied Physics Letters
Transmission electron microscopy (TEM) and photoluminescence (PL) spectroscopy were applied to study the metalorganic chemical vapor deposition of InGaN and the correlation between the structural properties and luminescence of -quantum well structures. A series of samples was grown varying only the growth duration for the InGaN under otherwise unaltered growth conditions. Composition analyses were carried out by measuring local lattice parameters from TEM images, which are directly related to the local In concentration. A rising average In concentration from 6.5% to 15.4% and a decreasing growth rate are observed with increasing growth duration. All samples show an inhomogeneous In distribution containing In-rich agglomerates with a size of only a few nanometers and less pronounced composition fluctuations on a scale of some 10 nm. The redshift of the PL peak energy with increasing quantum well thickness indicates that the luminescence is predominantly determined by the piezoelectric field.
28 February 2005 in IEEE Electron Device Letters
We report the AlGaN-GaN high-electron mobility transistors (HEMTs) grown and fabricated on patterned silicon (111) substrates. A crack-free AlGaN-GaN HEMT heterostructure was grown on top of rectangular silicon ridges patterned on the silicon substrate. Fabrication of HEMT on the ridges was demonstrated using a polyimide planarization process. Maximum drain current density of 1.05 A/mm and peak transconductance of 150 mS/mm were achieved with 1.0 μm gate-length. The current gain cutoff frequency and maximum frequency of oscillation were 9.7 and 20.5 GHz, respectively, for the 1 μm × 300 μm devices.
23 July 1999 in Applied Physics Letters
A comprehensive x-ray analysis including Θ–2Θ scans, reciprocal space mapping, and x-ray reflectivity of multiple quantum wells (MQWs) is presented. The layers were grown by low-pressure metal–organic chemical-vapor deposition. The strain state and the In concentration in (InGaN/GaN) MQW systems are evaluated with the help of reciprocal space maps around the symmetric (0002) and asymmetric Bragg reflections. Depending on the In incorporation, the MQW system is fully strained, partially relaxed, or exhibits phase decomposition effects. The room-temperature photoluminescence emission energy of a fully strained MQW sample is 2.792 eV, which is 133 meV less than the calculated energy gap of 2.925 eV.
25 October 2006 in Superlattices and Microstructures
27 January 2025 in Small Science
Layered 2D semiconductors have shown enhanced ion migration capabilities along their van der Waals (vdW) gaps and on their surfaces. This effect can be employed for resistive switching (RS) in devices for emerging memories, selectors, and neuromorphic computing. To date, all lateral molybdenum disulfide (MoS2)‐based volatile RS devices with silver (Ag) ion migration have been demonstrated using exfoliated, single‐crystal MoS2 flakes requiring a forming step to enable RS. Herein, present volatile RS with multilayer MoS2 grown by metal‐organic chemical vapor deposition (MOCVD) with repeatable forming‐free operation is presented. The devices show highly reproducible volatile RS with low operating voltages of ≈2 V and fast‐switching times down to 130 ns considering their micrometer‐scale dimensions. The switching mechanism is investigated based on Ag ion surface migration through transmission electron microscopy, electronic transport modeling, and density functional theory. Finally, a physics‐based compact model is developed and the implementation of the volatile memristors as artificial neurons in neuromorphic systems is exploredd.