8 January 2020 in IEEE Transactions on Wireless Communications
The autonomous underwater vehicle(AUV)-aided localization techniques for underwater acoustic devices show promising applications in many scenarios, and most researches in this area are based on the time of arrival (ToA) or the time difference of arrival (TDoA) measurements. However, these measurements are not readily available. To develop a more universally applicable scheme, we investigate the possibility of employing the Doppler shift measurements for underwater localization of acoustic devices in this paper. To be specific, we employ a low-complexity algorithm for Doppler estimation, and prove that the estimation error can be well approximated by zero-mean Gaussian distribution. Based on the Doppler estimates, we can obtain a series of nonlinear equations. To solve them, we propose a two-phase linear algorithm to obtain high-accuracy position information of the target devices. Compared with the conventional iterative algorithms, the proposed one does not require initial estimate. Both the closed-form localization error and the Cramér-Rao lower bound are presented. They prove to be consistent for reasonably small Doppler estimation error. Besides, we conduct simulations to verify the theoretical analysis. Moreover, the complexity of the proposed algorithm only grows linearly with the number of Doppler shift measurements.
9 October 2023 in IEEE Journal on Selected Areas in Communications
Next generation cellular network is expected to provide the simultaneous high-accuracy localization and ultra-reliable communication services, even in high mobility scenarios. To that end, the novel orthogonal time frequency space (OTFS) modulation has been developed as a promising physical-layer transmission technique, evident by the outstanding performance in terms of robustness against time-frequency selective fading over the orthogonal frequency division multiplexing (OFDM) counterpart. However, when OTFS meets massive multiple-input multiple-output (MIMO), the specific conditions, under which the delay-Doppler (DD) domain channel model holds, are not identified. In addition, the channel estimation and localization performance in such system is rarely studied. In this work, we target at these new challenges, and conduct comprehensive modelling, performance analysis, and algorithm design for massive MIMO-OTFS based simultaneous localization and communications. Specifically, we derive new channel models for the massive MIMO-OTFS system, which captures both time-frequency dispersion and spatial wideband effects. The specific conditions, under which the new models hold has been unveiled as well. Based on the new models, we establish the theoretical foundations for channel estimation and localization, by deriving the Cramér-Rao lower bounds of channel parameter and location estimation errors. Such bounds have been achieved with the newly designed low-complexity channel estimation and localization algorithms. Numerical simulations of the proposed framework with prevailing pulse functions are also conducted and the results validate the proposed designs and analysis.
6 November 2020 in IEEE Transactions on Vehicular Technology
The localization and tracking of underwater objects have many applications. In a proactive underwater sensor array, some nodes will periodically broadcast linear frequency modulated (LFM) signals, which will hit the targets, get reflected and received by the other nodes. Depending on the target's position and velocity, the received signals will also be LFM signals of different frequencies and frequency rates. We can use the Fractional Fourier Transform (FrFT) to analyze the received signal's spectrum and find the peak. Based on the location of the peak, the target's distance and radial velocity can be estimated. However, the accuracy is highly dependent on the sampling interval of the spectrum. Smaller sampling interval leads to higher accuracy but also induces great complexity. To overcome this issue, we propose a machine learning-based approach to automatically detect the existence of the target, and roughly estimate the peak's location if targets exist. Then over-sampling can be conducted for a small area around the peak, leading to improved accuracy and reduced complexity. This idea is based on the following observation: if a target exists, we will be able to observe an “X” pattern on the spectrum. Extensive simulations are conducted to verify the effectiveness of the proposed architecture.
30 September 2020 in IEEE Transactions on Wireless Communications
Millimeter wave communications show great potentials in many applications, one of which is the high-speed railway (HSR) communication system. However, a major challenge is the Doppler effect caused by the relative-movement between the train and the base station (BS), which leads to fast channel variation. To compensate for the Doppler shift, an accurate channel model is indispensable, and the far-field channel model is generally employed, which assumes that the dimensions of the antenna arrays are negligible compared to the distance between transmitter and receiver. This model is widely used in Cellular systems, but the underlining assumption is not always true for railway communication systems. In this paper, the modeling of the Doppler effect for millimeter wave in HSR communications is conducted, and data-aided Doppler estimation and compensation algorithms are designed based on the new model. We show that the conventional far-field channel model is based on the first-order Taylor expansion of the actually channel, and the second-order component cannot be ignored for HSR communications. Extensive simulations are conducted to verify the validity of the new model and the effectiveness of the proposed algorithms.
27 January 2021 in IEEE Transactions on Vehicular Technology
Underwater acoustic sensor networks (UWSNs), acting as a reliable and efficient infrastructure of the Internet of underwater things (IoUT), have attracted much research interest in recent years due to the wide range of their potential marine applications. The limited energy supply of underwater sensor nodes is a significant challenge that can be mitigated by the cyclic difference set (CDS)-based coordination asynchronous wake-up scheme. However, the CDS-based asynchronous wake-up scheme also introduces long delays in the neighbor discovery that deteriorates packet delay as well as the network lifetime. In this paper, we formulate the problem of policy selection for idle listening as a Markov decision process and exploit the framework of deep reinforcement learning to obtain the optimal policies of underwater sensor nodes. Furthermore, the long short-term memory (LSTM) networks are utilized to estimate the network traffic feature, which can improve the performance of the proposed adaptive asynchronous wake-up scheme. To verify the performance of the proposed scheme, simulations in different network scenarios are conducted with the comparison of random, fixed metric policies, and original CDS-based asynchronous wake-up schemes.
7 August 2019 in IEEE Journal of Selected Topics in Signal Processing
In millimeter wave communication systems, channel estimation consumes large amount of resources in terms of time, bandwidth, and hardware. However, the properties that the millimeter wave channels are generally sparse in space and channel states in consecutive time slots are highly correlated in angle domain made it possible to track the channel state with much reduced resource requirements. For millimeter wave communications, the antenna array form is important. In this paper, we employ a lens antenna array because it has much lower complexity and it allows the base station to use only a few RF (Radio Frequency) chains for beamforming. Based on the lens antenna array and the spatial sparsity of the millimeter wave channels, we propose a data-aided channel tracking scheme for vehicle-to-infrastructure (V2I) communication systems, where high-mobility of mobile users is expected. The basic idea is to employ the channel estimate from the previous time slot for the current data detection. After data detection, the detected data sequence can be used for channel update, and this process iterates. By doing this, the overhead of channel estimation can be greatly reduced. We evaluate the performance of the proposed algorithm through theoretical analysis and simulations. Highly promising results are obtained using our proposed method when compared with theoretical bounds and other existing methods.