Claudia Rodrigues de Oliveira

Claudia Rodrigues de Oliveira

Auto-generated profile, based on publicly available information

Claudia Rodrigues de Oliveira

Department of Materials Engineering , São Paulo State University (UNESP) , Guaratinguetá , Brazil

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 April 2023 in Concilium
Verified
Journal Article
Open access
PDF file
FLFelipe Oliveira Lima
Felipe Oliveira Lima
LSLuana Cristal Lirya Silva
Luana Cristal Lirya Silva
RMRosangela Almeida Maia
Rosangela Almeida Maia
IOIliane Rodrigues de Oliveira
Iliane Rodrigues de Oliveira
COCláudia Rodrigues de Oliveira
Cláudia Rodrigues de Oliveira
CCCristiane Inácio de Campos
Cristiane Inácio de Campos
The need for more technological products increases with nanomaterials as a viable proposal, presenting good results in many different industrial sectors, especially in wood panels. Particleboards are composites of wood that have been extensively studied, mainly in relation to the adhesives used in their manufacture, which have an influence on particleboard properties. Thus, as a way of improving these adhesives, zinc oxide nanoparticles were added, giving new properties to the particleboard. Thereby, the present work aimed to produce particleboard with the wood of Eucalyptus Urophila x Grandis hybrid and urea-formaldehyde adhesive with ZnO nanoparticles addition. The physical tests performed were density, moisture content, and thickness swelling. The mechanical tests performed were the modulus of elasticity, modulus of rupture, and bonding tests. The results obtained were submitted to statistical analysis and compared with the requirements standards, as well as with works found in the literature. The addition of zinc oxide nanoparticles did not exercise influence on mechanical tests; however, the physical properties were improved, mainly decreasing the thickness swelling, which is usually a problem for wood products.

29 September 2026 in Nordic Pulp & Paper Research Journal
Verified
Journal Article
Closed access
COClaudia Rodrigues de Oliveira
Claudia Rodrigues de Oliveira
GVGustavo Ventorim
Gustavo Ventorim
MSMargarida Juri Saeki
Margarida Juri Saeki
IOIliane Rodrigues de Oliveira
Iliane Rodrigues de Oliveira
The growing demand for sustainable materials has increased interest in nanocellulose derived from renewable resources. This study investigated the influence of different bleaching sequences on the production and characteristics of nanocellulose from Eucalyptus urograndis pulp. Three bleaching sequences, D 0 ( E + P ) D 1 P 2 , A HT DP 2 , and A HT E HT DP 1 , were evaluated using an industrially bleached pulp as reference. Nanocellulose was produced by sulfuric acid hydrolysis at 63 % (v/v), 55 °C, and 30 or 40 min, followed by centrifugation, dialysis, and ultrasonication. Increasing the hydrolysis time from 30 to 40 min consistently reduced the hydrodynamic diameter and polydispersity index, while the different bleaching conditions showed a similar response. FEG-SEM revealed nanometric structures with average widths of 32–41 nm and lengths of 293–353 nm, with yields close to 80 %. XRD, FTIR, and TG/DTG analyses showed similar crystalline, chemical, and overall thermal characteristics among the samples. Overall, under the conditions investigated, hydrolysis time showed a more consistent influence on hydrodynamic size distribution than the bleaching sequence, while the evaluated bleaching sequences resulted in nanocellulose with comparable morphological and structural characteristics.