5 August 2019 in Advanced Electronic Materials
A model device based on an epitaxial stack combination of titanium nitride (111) and monoclinic hafnia (11) is grown onto a c‐cut Al2O3‐substrate to target the role of grain boundaries in resistive switching. The texture transfer results in 120° in‐plane rotated m‐HfO2 grains, and thus, in a defined subset of allowed grain boundary orientations of high symmetry. These engineered grain boundaries thread the whole dielectric layer, thereby providing predefined breakdown paths for electroforming‐free resistive random access memory devices. Combining X‐ray diffraction and scanning transmission electron microscopy (STEM)–based localized automated crystal orientation mapping (ACOM), a nanoscale picture of crystal growth and grain boundary orientation is obtained. High‐resolution STEM reveals low‐energy grain boundaries with facing () and (21) surfaces. The uniform distribution of forming voltages below 2 V—within the operation regime—and the stable switching voltages indicates reduced intra‐ and device‐to‐device variation in grain boundary engineered hafnium‐oxide‐based random access memory devices.
22 June 2016 in Journal of the American Ceramic Society
20 November 2012 in ACS Applied Materials & Interfaces
29 March 2002 in Physical Review Letters
The domain structure of an antiferromagnetic superlattice is studied. Synchrotron Mössbauer and polarized neutron reflectometric maps show micrometer-size primary domain formation as the external field decreases from saturation to remanence. A secondary domain state consisting mainly of at least 1 order of magnitude larger domains is created when a small field along the layer magnetizations induces a bulk-spin-flop transition. The domain-size distribution is reproducibly dependent on the magnetic prehistory. The condition for domain coarsening is shown to be the equilibrium of the external field energy with the anisotropy energy.
15 September 2014 in Journal of Applied Physics
We have investigated the origin of superstructure peaks as observed by X-ray diffraction of multiferroic Bi(Fe0.5Cr0.5)O3 thin films grown by pulsed laser deposition on single crystal SrTiO3 substrates. The photon energy dependence of the contrast between the atomic scattering factors of Fe and Cr is used to rule out a chemically ordered double perovskite Bi2FeCrO6 (BFCO). Structural calculations suggest that the experimentally observed superstructure occurs due to unequal cation displacements along the pseudo-cubic [111] direction that mimic the unit cell of the chemically ordered compound. This result helps to clarify discrepancies in the correlations of structural and magnetic order reported for Bi2FeCrO6. The observation of a superstructure in itself is not a sufficient proof of chemical order in double perovskites.
1 December 2009 in Review of Scientific Instruments
We present a dedicated experimental spin-echo resolved grazing incidence scattering (SERGIS) setup for the investigation of surfaces and thin films exhibiting large lateral length scales. This technique uses the neutron spin to encode one in-plane component of the wave-vector transfer in a grazing angle scattering experiment. Instead of the scattering angle, the depolarization of the scattered beam is measured. This allows one to achieve a very high in-plane momentum resolution without collimation of the incident neutron beam in the corresponding direction. SERGIS can therefore offer an alternative or complementary method to conventional grazing incidence neutron scattering experiments. We describe the experimental setup installed at the neutron sources ILL (Grenoble) and FRM II (Garching) and present data obtained with this setup on various samples exhibiting characteristic mesoscopic length scales in the range of several hundred nanometers. We also derive general formulas and error margins for the analysis and interpretation of SERGIS data and apply them to the cases of a one-dimensional structure and of an island morphology.