Multipactor has become a keylimiting factor of the final performance of satellite communication systems, due to the increase in power levels and/or operating frequency bands. As a result, the critical components of these systems must meet demanding multipactor specifications which should be considered during the design process. This paper describes the different techniques available to predict the multipactor threshold power for radio frequency (RF) and microwave passive hardware under continuous wave (CW) excitation, from cumbersome particle simulations to fast approximate methods based on circuit models. All these techniques have been described and compared together for the first time, including also a detailed description of the configuration issues of commercial particle simulators required to obtain accurate multipactor threshold predictions. The techniques are applied to both wideband and narrowband application examples. The predictions have been compared with measured thresholds of manufactured samples obtained with a novel multipactor test bed, thus allowing to highlight the advantages and limitations of each technique and particle simulator. From this paper, it will be possible to choose the most suitable procedure (and an appropriate simulator, if needed) to obtain multipactor threshold prediction of passive hardware.
Multipactor is a harmful effect that may challenge the correct operation of satellite communication systems by limiting the system power-handling capability, and hence its overall performance. Therefore, the development of techniques for predicting the multipactor threshold is of great practical interest. For narrowband components, rough estimations can be obtained from experimental charts, normally resulting in conservative thresholds. More accurate predictions can be obtained with particle simulators, at the expense of a much higher computational effort. This study proposes an approach based on circuital models for swift and accurate multipactor threshold predictions, specifically addressing short-term discharges induced by multicarrier signals in narrowband samples. The use of reduced, but representative, electromagnetic (EM) models of the critical gap region is discussed in detail. Through the use of these models, it is possible to avoid simulating the complete structure, increasing the computational efficiency and enabling the fulfillment of the power requirements at early design stages. The proposed technique is validated through commercial particle simulators, showcasing its efficacy, efficiency, and key benefits.
1 February 2023 in IEEE Microwave and Wireless Technology Letters
Multipactor (MP) is a high-power effect severely limiting the performance of satellite communication links. A reference sample is normally used in the experimental setups for MP testing in order to verify its correct operation. However, the low gaps required for high frequencies jeopardize the manufacturability of the devices traditionally used for this purpose. A new reference sample, based on a stepped-impedance resonator (SIR), is proposed in this letter. The key design considerations are also outlined. A prototype operating between 17 and 18 GHz has been manufactured and tested, proving the novel structure allows higher gaps, and is, thus, suitable for higher frequency bands.