12 October 2024 in npj Computational Materials
Strain engineering is a widely used technique for enhancing the mobility of charge carriers in semiconductors, but its effect is not fully understood. In this work, we perform first-principles calculations to explore the variations of the mobility of electrons and holes in silicon upon deformation by uniaxial strain up to 2% in the [100] crystal direction. We compute the π11 and π12 electron piezoresistances based on the low-strain change of resistivity with temperature in the range 200 K to 400 K, in excellent agreement with experiment. We also predict them for holes which were only measured at room temperature. Remarkably, for electrons in the transverse direction, we predict a minimum room-temperature mobility about 1200 cm2 V−1 s−1 at 0.3% uniaxial tensile strain while we observe a monotonous increase of the longitudinal transport, reaching a value of 2200 cm2 V−1 s−1 at high strain. We confirm these findings experimentally using four-point bending measurements, establishing the reliability of our first-principles calculations. For holes, we find that the transport is almost unaffected by strain up to 0.3% uniaxial tensile strain and then rises significantly, more than doubling at 2% strain. Our findings open new perspectives to boost the mobility by applying a stress in the [100] direction. This is particularly interesting for holes for which shear strain was thought for a long time to be the only way to enhance the mobility.
17 May 2024 in Nano Letters
4 February 2023 in Journal of Materials Science: Materials in Electronics
4 August 2021 in Journal of Applied Physics
The optical properties of silicon can be greatly tuned by applying strain and opening new perspectives, particularly in applications where infrared is key. In this work, we use a recent model for the indirect light absorption of silicon and include the effects of tensile and compressive uniaxial strains. The model is based on material properties such as the bandgap, the conduction and valence band density-of-states effective masses, and the phonon frequencies, which are obtained from first principles including strain up to % along the [110] and [111] directions. We show that the limit of absorption can increase from 1.14 (1.09) to 1.35 m (0.92 eV) under 2% strain and that the absorption increases by a factor of 55 for the zero-strain cutoff wavelength of 1.14 m when a 2% compressive strain is applied in the [110] direction. We demonstrate that this effect is mainly due to the impact of strain on the electronic bandgaps of silicon, directly followed by the valence band density-of-states effective mass.
20 September 2023 in Optical Materials
27 February 2025 in IEEE Transactions on Electron Devices
This work investigates the robustness of an ultrathin backside-illuminated (BSI) silicon-on-insulator (SOI) single-photon avalanche diode (SPAD) against gamma-ray irradiation for space applications. Experimental results demonstrate a breakdown voltage shift in the studied SPAD from 10.17 to 9.95 V after a total ionizing dose (TID) of 132 krad(Si). An increase in dark count rate (DCR) from 1490 to 2700 cps/μm2 at 1 V excess bias is shown at this dose. TCAD simulations explain the role of the oxide-trapped charges, induced by irradiation in the insulating layer surrounding the active region, on the SPAD performance. These trapped charges shift the peak electric field, leading to premature breakdown while the extension of the active area affected by impact ionization increases the DCR. Further simulations show that implementing a perimeter-gated structure and reducing oxide thickness can effectively mitigate these effects by leveraging capacitive effects, preventing a breakdown voltage shift. The perimeter gate (PG) lowers the simulated DCR after irradiation from 2700 to 1365 cps/μm2, thereby enhancing the radiation resilience of ultrathin SOI SPADs beyond a TID of 132 krad(Si).