Objective: To compare the biomechanical stability of 3 fixation techniques for unilateral sacroiliac (SI) luxation using 3-D–printed feline pelvic models. Methods: Eighteen 3-D–printed pelvic models were generated from CT data of a 6.6-kg cat. The study was conducted from July 25 through September 10, 2025. A right SI luxation with ipsilateral pubic and ischial osteotomies was created, and models were fabricated for 3 fixation configurations (n = 6/group): single lag screw with transiliac pinning (SP), double parallel Kirschner wires (DK), and double J-shaped Kirschner wires (DJ). A 3-D–printed femur was toggle pinned to the acetabulum to reproduce stance. Axial compression was applied to the femoral head at 5 mm/min to 15° pelvic rotation. Outcomes included rotational stiffness (primary), maximum load at 10° rotation, and energy absorption. Results: DJ constructs showed approximately 3-fold greater initial rotational stiffness and higher energy absorption than SP and DK. Mean maximum load to 10° rotation was 93.10 N for DJ versus 33.32 N (SP) and 36.59 N (DK). No differences were detected between SP and DK for any parameter. Conclusions: In this ex vivo 3-D–printed model, DJ fixation provided superior rotational stability compared with SP and DK techniques. Clinical Relevance: The DJ technique may offer a biomechanically robust alternative for stabilizing feline SI luxation. By avoiding the narrow sacral safe corridor required for lag screw placement, this method may reduce the risk of iatrogenic nerve injury while preserving sacral bone integrity to ensure optimal purchase and minimize the risk of fixation failure during stabilization.
20 February 2026 in American Journal of Veterinary Research
Objective: To compare the tensile performance of 3 constructs for feline greater trochanter (GT) avulsion fractures using a cadaveric model. Methods: An experimental cadaveric study was performed using a standardized GT osteotomy model. Adult feline cadavers euthanized for reasons unrelated to this study and without radiographic evidence of orthopedic disease were included; specimens with musculoskeletal abnormalities were excluded. All testing was conducted at a single academic biomechanics laboratory. Fixation constructs were subjected to quasistatic tensile loading until failure. Results: 18 hindlimbs from 9 feline cadavers were allocated equally to bicortical pin tension-band wiring (TBW; n = 6), tricortical pin TBW (6), and FiberWire-only fixation (6). At 3-mm displacement, tricortical fixation demonstrated higher mean load resistance than both bicortical fixation (mean difference, 45.0 N; 95% CI, 19.7 to 70.3 N) and FiberWire-only fixation (mean difference, 140.5 N; 95% CI, 115.1 to 165.9 N). Bicortical and tricortical constructs exhibited similar resistance at 1- and 2-mm displacement. Conclusions: Tricortical pin TBW provided the greatest tensile resistance under maximal loading. However, the bicortical pin TBW and tricortical pin TBW techniques provided similar strength during early displacement. The FiberWire-only fixation construct demonstrated the lowest stability, suggesting that FiberWire fixation alone may not provide sufficient strength or an optimal tension-band configuration for feline GT avulsion repair. Clinical Relevance: For routine feline GT, bicortical pin TBW may offer a practical balance of strength and simplicity. Tricortical pin TBW fixation may be reserved for cases requiring maximal resistance, whereas FiberWire-only fixation should be used with caution due to its lower load-bearing capacity.