23 January 2024 in IEEE Journal of Solid-State Circuits
A sub-THz (88–136 GHz) full-duplex (FD) phased-array transceiver (TRX) integrating an RF self-interference (SI) canceller with differential feeding FD antennas is presented in this work. The LO phase generation chain controls differential transmitter outputs for the phased-array operation. The differential feeding FD antenna with differential pairs of chips achieves over 35-dB SI suppression. The SI suppression is improved by 20 dB when the SI canceller is turned on. Without any digital-domain SI cancellation (SIC), a total SI suppression of $>$ 60 dB is achieved over a 2-GHz bandwidth. The proposed neutralized mixer with over 20-dB LO feedthrough suppression and wideband RF amplifiers support a large data rate at sub-THz frequencies. This is the world’s first demonstrated sub-THz FD phased-array TRX. In the over-the-air (OTA) measurements for FD mode, the proposed FD TRX achieves 6 Gb/s in 8PSK and 4 Gb/s in 16QAM. It also achieves a 112-Gb/s data rate for OTA TX-to-RX.
19 December 2024 in IEEE Journal of Solid-State Circuits
This work presents a D-band (110–170 GHz) CMOS transceiver (TRX) chipset that covers a 56-GHz (114–170 GHz) signal-chain bandwidth. Both the transmitter (TX) and the receiver (RX) operate as heterodyne architectures with external intermediate frequency (IF) and local oscillator (LO) signals. An eight-way low- Q power-combined power amplifier (PA), a two-way low- Q power-combined low-noise amplifier (LNA), wideband-impedance-transformation passive mixers, common-source-based cascaded distributed amplifiers (DAs), and a low-loss wideband chip-to-waveguide printed circuit board (PCB) transition are proposed with improved bandwidth and linearity to support high-order wideband quadrature amplitude modulation (QAM) signals. The TRX chipset was fabricated using a 65-nm CMOS process. The TX achieves a 13-dBm saturated output power at 130 GHz with 1150-mW dc power. The RX achieves a 12-dB noise figure (NF) with 550-mW dc power. The proposed TRX chipset achieves a data rate of 200 Gb/s by 32QAM in the single-input–single-output (SISO) over-the-air (OTA) measurement at 0.32 m. A data rate of 150 Gb/s by 16QAM is realized with 43-dBi antennas at 15 m. Additionally, a 640-Gb/s 4 $\times$ 4 OTA line-of-sight multiinput multioutput (LOS-MIMO) is demonstrated at 0.52 m.
3 July 2024 in IEEE Open Journal of Antennas and Propagation
As the CMOS transceiver reaches the sub-millimeter wave operating frequency, its circuit area cannot keep up with the shrinkage of the 0.5λ0 × 0.5λ0 area limit for the typical 2-dimensional (2D) tile-based phased array topology. This article proposes an end-fire on-chip Vivaldi antenna on a standard 65-nm CMOS process for the 300 GHz band operation. The Vivaldi architecture was chosen for its broadband and end-fire radiation characteristics. End-fire antenna is required for slat array topology, which enables 2D array implementation for transceivers with circuit area above 0.5λ0 × 0.5λ0. The antenna length was shortened to maximize beamwidth and reduce area. Additionally, comb-shaped slots were added to suppress side lobes and back radiation caused by the short length. To prevent higher mode surface waves from distorting the antenna radiation pattern and reducing efficiency, the substrate was thinned to 50 m. A dual-layer proton irradiation process increases the substrate resistivity to 1 kΩ-cm, allowing high-efficiency on-chip antenna implementation on low-cost CMOS processes. The manufactured on-chip Vivaldi antenna has an area of 0.45λ0 × 0.45λ0, with measurement results showing 6 dBi gain with 1 dB flatness from 220 GHz to 320 GHz (37% bandwidth) and 76° E-plane beamwidth at 270 GHz with 87% efficiency. A 1 × 4 slat array implementation using the proposed on-chip Vivaldi antenna has been demonstrated, with measurement results showing a 56° beam steering range across the E-plane.
26 April 2024 in IEEE Solid-State Circuits Letters
A D-band wideband passive single-ended upconversion mixer with controlled LO feedthrough in 65-nm CMOS process is presented in this letter. The LO feedthrough was controlled by the varactor and the neutralizing transmission line between the LO and RF ports of the mixer. In measurement, the proposed passive single-ended mixer had a conversion gain of −13.0±1.5 dB with an ultrawide 3-dB bandwidth from 110 to 160 GHz. The LO feedthrough suppression was from −38.9 to −24.4 dB at 135 GHz by changing the varactor bias. The measured OP1dB was −12.5 dBm at center frequency. The chip occupies 0.35 mm2, including pads.
1 January 2026 in IEEE Journal of Solid-State Circuits
3 March 2026 in IEEE Journal of Solid-State Circuits
This work presents a D-band high-power-density four-element phased-array transceiver for 6G user equipment (UE). Conventional designs require large multi-stage LO generation circuits for D-band up/down conversion, making it difficult to achieve compact size and low-power consumption. To address this, we propose an integrated LO chain using an injection-locked tripling phase shifter (ILTPS), which enables both frequency tripling and phase shifting within a single circuit without multi-stage amplifiers. The ILTPS achieves an area of 0.088 mm2 and a power consumption of 15 mW. In addition, to realize high power density, the transceiver integrates a bi-active sub-harmonic mixer (BA-SHM) and a D-band PA/LNA with PA-sharing TDD switching. An eight-element antenna-in-package (AiP) module using two transceiver ICs operates in the 142–164-GHz frequency range, achieving an EIRP of 25.7 dBm and a maximum data rate of 56 Gbps. The power consumption per element is 150 mW in TX mode and 93 mW in RX mode with 1 V VDD. The active area of this transceiver is 8.5 mm2, and it is implemented using a 65 nm CMOS process.