22 April 2013 in Optics Express
The flexible control of surface plasmon polaritons (SPPs) is important and intriguing due to its wide application in novel plasmonic devices. Transformation optics (TO) offers the capability either to confine the SPP propagation on rigid curved/uneven surfaces, or to control the flow of SPPs on planar surfaces. However, TO has not permitted us to confine, manipulate, and control SPP waves on flexible curved surfaces. Here, we propose to confine and freely control flexible SPPs using TO and graphene. We show that SPP waves can be naturally confined and propagate on curved or uneven graphene surfaces with little bending and radiation losses, and the confined SPPs are further manipulated and controlled using TO. Flexible plasmonic devices are presented, including the bending waveguides, wave splitter, and Luneburg lens on curved surfaces. Together with the intrinsic flexibility, graphene can be served as a good platform for flexible transformation plasmonics.
24 May 2018 in IEEE Transactions on Microwave Theory and Techniques
Radar-absorbing materials are used in stealth technologies for concealment of an object from radar detection. Resistive and/or magnetic composite materials are used to reduce the backscattered microwave signals. However, nontunable characteristics or the required complex structure hampered the application of these materials. Here, multilayer graphene-based frequency selective surfaces (MLGFSS), which reach a size of 150 mm $x$ 150 mm, are designed and fabricated. By properly changing the growth temperature of MLG using the chemical vapor deposition approach and designing the pattern of graphene layer, the impedance matching condition can be satisfied at different frequencies. As a result, two kinds of absorbers with different working bandwidths are realized. The performances of the proposed absorbers are analyzed using full-wave simulation and are also tested with experimental results. Our method of fabricating large-area MLGFSS avoids the direct contact between the stencil mask and graphene, and guarantees the integrity and quality of patterned graphene structure. A good agreement between simulation and measurement results demonstrates that such ultrathin MLGFSS is very useful in the design of graphene-based functional devices at microwave frequencies.
14 October 2021 in IEEE Transactions on Antennas and Propagation
In this article, we demonstrate a flexible and wearable hybrid radio frequency (RF) and solar energy harvesting system for powering wearable electronic devices. The system consists of a flexible transparent antenna, a flexible transparent rectifying circuit, and an amorphous silicon solar cell. By utilizing transparent stacked structure, the rectenna and the solar cell can provide more hybrid output power to accommodate more application scenarios. The flexible transparent antenna shows two impedance matching bandwidths of 3.5–3.578 and 4.79–5.09 GHz, covering n78/n79 fifth-generation (5G) communication frequency band and 5-GHz WiFi frequency band. At the frequency of 3.5 GHz, the flexible transparent rectifying circuit achieves a high RF-to-dc conversion efficiency of 54.67% at 13 dBm RF input power. In the room with a light intensity of 210 lux, compared with a single solar cell, the hybrid energy harvesting system can obtain an additional 35.6%–769.5% output power when the RF source power is varied from 4 to 10 dBm. These results demonstrate that the proposed flexible and wearable RF-solar energy harvester can provide reliable electric power supply, which can be a potential candidate for powering wearable electronic devices, distributed sensors and IOT devices.
5 May 2020 in ACS Photonics
1 November 2019 in Carbon
16 July 2024 in Energy & Environmental Science
Hydrogel electrolytes are the ideal platform to construct flexible zinc-ion batteries. However, they usually require immersion in salt solutions to the swollen state for high ion transportation, resulting in a decreased energy density and poor interface adhesion. Herein, we developed a hydrophobic–hydrophilic dual phase stabilization strategy to crosslink polymer membranes into hydrogels based on solvent displacement. The hydrophobic and rigid polyacrylonitrile (PAN) network effectively restricts the swelling behavior of the hydrophilic polyvinyl alcohol (PVA) network, forming an interconnected amphiphilic hydrogel (C-PVA/PAN) with a thickness of only 20 μm even after swelling. The Zn||C-PVA/PAN||Zn symmetric cell cycling tests demonstrate stable performance exceeding 3500 hours without zinc dendrite formation. Molecular dynamics (MD) simulations also corroborate the ability of the C-PVA/PAN hydrogel electrolyte to facilitate uniform zinc deposition. Additionally, paper-like Zn||C-PVA/PAN||NH4V4O10 batteries with a thickness of only 82 μm exhibit remarkable cycling performance (180 mA h g−1 after 3000 cycles at 20 A g−1) and can be folded using the Miura folding technique, significantly enhancing areal energy density. This work presents a facile strategy for designing ultra-thin hydrogel electrolytes, paving the way for powering next-generation flexible electronics through paper-like batteries.